Ferguson Ariva 120 Users Thread

Peter Rhea

If you're receiving the UK channels from a transmitter in the north (Brougher Mountain most likely) & not some local 'deflector', you stand a chance of getting at least some of the Freeview channels after switchover, when the power will be increased.

NI switchover starts on October 10th.

Tony

Could be an antenna or cabling problem, try a terrestral manual scan and see what quality and signal readings you are getting.

Omeceron wrote: »

Hi

Im having a couple of problems with my Ariva.

1. My Saorview channels freeze picture and sound approx once a minute. Sometimes a message pops up saying "No Signal" as it freezes. It freezes for around 1-2 seconds and then fixes itself, until the next freeze.

zg3409

Omeceron wrote: »

1. My Saorview channels freeze picture and sound approx once a minute. Sometimes a message pops up saying "No Signal" as it freezes. It freezes for around 1-2 seconds and then fixes itself, until the next freeze.

2. My UK freeview channels disappear completely. I could be watching BBC and if I scroll to RTE, BBC and the other UK freeview channels will all disappear. If I restart the box these channels return. This does not happen very regularly. When this happens the Saorview channels are unaffected.
.

Both problems seem to be nothing to do with the box but with your aerial setup. A professionally installed aerial pointed in the right direction and matched to your local needs would be best.

If you have a 120 then you should be getting most of the UK channels via the dish. The freeview channels via the aerial will increase in power come November but depending on where you live they may or may not be reliable.

I would recommend get a good installer who can install two aerials, one for Saorview and another for Freeview and combine and boost them as needed depending on where you live. A DIY install for combined Freeview and Saorview is difficult but this page may explain better:
http://www.tvtrade.ie/how-to-combine-saorview-and-freeview-on-the-same-digital-receiver.html

Spocker

gerryirl wrote: »

HI I got one of these box's the ariva 120 yesterday. I don't have a satellite just an ariel. The question I have is can I get the bbc's utv channel 4 with it. I am only getting the Irish channels so far and maybe there is something I have to do to get the other channels or do I just have to get satellite.

Thanks in advance

Simple answer is that you'll need to get a satellite dish installed , and then connect that dish to your combo box, to receive BBC etc

Omeceron

Tony wrote: »

Could be an antenna or cabling problem, try a terrestral manual scan and see what quality and signal readings you are getting.

Signal Intensity is 77% and Quality is 90%.

I have the 120 about 9 months but this issue only started 2 weeks ago.

Ronnie Raygun

Are you receiving the "UK freeview" channels referred to via satellite?

If so, the problem there is unrelated to the Saorview "no signal" issue & is probably software related.

The Saorview problem is most likely, as mentioned already, due to a poor aerial setup. Don't put too much faith in receiver signal readings.

dodzy

Omeceron wrote: »

Signal Intensity is 77% and Quality is 90%.

I have the 120 about 9 months but this issue only started 2 weeks ago.

Going by those readings, you should be fine.Personally, I'd upgrade the FW. You mentioned that it has never been updated. Give it a go. Probably just a "glitch":)

STB

Omeceron wrote: »

Hi

Im having a couple of problems with my Ariva.

1. My Saorview channels freeze picture and sound approx once a minute. Sometimes a message pops up saying "No Signal" as it freezes. It freezes for around 1-2 seconds and then fixes itself, until the next freeze.

2. My UK freeview channels disappear completely. I could be watching BBC and if I scroll to RTE, BBC and the other UK freeview channels will all disappear. If I restart the box these channels return. This does not happen very regularly. When this happens the Saorview channels are unaffected.

Any ideas how to fix? I haven't changed firmware, etc since I got the box.

This is not related to the Ariva box at all. It is to do with your aerial setup. You say that you are receiving both Freeview and Saorview Channels so you must be in a border area/east coast.

This scenario is typical of a high gain amplified aerial pointing to a Freeview transmitter with the Saorview signal probably coming in the back of the aerial. It may need tweaking and is a fine balance. Either way maximising the setup tomorrow doesn't mean that you will not be subject to all kinds of gremlins during atmospheric conditions.

Also bear in mind that whilst you may get a perfect signal of one mux, it is not telling you the whole story, especially using the one setup to try and balance the pulling in of distant signals and containing those very near. Bear in mind that the Ariva BER readings are not accurate.

Ronnie Raygun

STB wrote: »

You say that you are receiving both Freeview and Saorview Channels so you must be in a border area/east coast.

It isn't wise to assume that people know that Freeview is the UK terrestrial service.

STB

Ronnie Raygun wrote: »

It isn't wise to assume that people know that Freeview is the UK terrestrial service.

That's the way i read it, scrolling part caught my attention so I am not second guessing that the OP doesnt know what he is talking about. There are quite a few old aerial setups optimised for UK analogue that cause these type problems when trying to do the something similar over DVB-T as you well know. It sounds like one of these.

Group/Wideband aerials are the next questions of course and depending on the current users setup and future changes in power this is not a good time to be setting up aerials (to do both) as the installer most likely will have to return in October when either the frequencies change or power is increased. Mt Leinster and NI scenarios.

Something that a local installer should know (but the OP should be aware of too).

Omeceron

Im based in the Midlands. Im getting Saorview from Mt Leinster and Freeview via my old sky dish.

The problem with the Saorview is intermittent. It was very bad this morning and all during the day, but its fine now.

The issue with the Freeview channels disappearing is not major, I can restart the box and they come back.

The Saorview problem makes those channels unwatchable. Ill update the FM tomorrow and see if that helps.

Thanks for the help.

STB

Ronnie Raygun wrote: »

It isn't wise to assume that people know that Freeview is the UK terrestrial service.

It certainly isn't

Omeceron wrote: »

Im based in the Midlands. Im getting Saorview from Mt Leinster and Freeview via my old sky dish.

The problem with the Saorview is intermittent. It was very bad this morning and all during the day, but its fine now.

The issue with the Freeview channels disappearing is not major, I can restart the box and they come back.

The Saorview problem makes those channels unwatchable. Ill update the FM tomorrow and see if that helps.

Thanks for the help.

Freeview = terrestrial off an aerial. Freesat or FTA Satellite = Satellite

Your problem with Saorview relates to your aerial positioning/cabelling/type.

Tony

Omeceron wrote: »

Im getting Saorview from Mt Leinster and Freeview via my old sky dish.

Freeview is a terrestrial service not satellite, what you are receiving via the dish are freesat channels.

Nowso

im having problems getting dvb-s2 channels to tune in . previously the olympic streams on astra 28 and now dvb-s2 hd channels on hotbird 13.

what can i do it is worth reloading firmware?

also what is the best lnb setting to use when using hotbird ? universal upto 10.600 or 10.750 or which?

Peter Rhea

Leave the lnb settings on 'universal' (9750 & 10600 LO).

Nowso

Peter Rhea wrote: »

Leave the lnb settings on 'universal' (9750 & 10600 LO).

thanks may reset and research .:) probably still may not get dvb-s2 hd stations :mad:

Tony

Updating the firmware is not the answer, something else is causing this.

Nowso wrote: »

im having problems getting dvb-s2 channels to tune in . previously the olympic streams on astra 28 and now dvb-s2 hd channels on hotbird 13.

what can i do it is worth reloading firmware?

Nowso

Tony wrote: »

Updating the firmware is not the answer, something else is causing this.

what could it it be is there any settings that would effect this.

i will try using a different box to check signal is there but since the olympics channels worked on another box of same satellite

Tony

Nowso wrote: »

what could it it be is there any settings that would effect this.

Have you changed any settings?

zg3409

It might be that the signal is a bit weak and the receiver needs a better signal to decode the S2 signal. Try the receiver at another house to see if it is a weak signal issue. Sensitivity of receivers can vary.

Nowso

i may have to adjust the satellite. The super tennis hd is fine .

Iv reset also

STB

Nowso wrote: »

i may have to adjust the satellite. The super tennis hd is fine .

Iv reset also

Upgrade the firmware. It must be very old firmware are not common.

paddydu

Hi can i play a dvd from my laptop through the 120 box so i can watch it on tv? Im worried to mess about in case i upset something with my 120 box cause it has been working problem free for the last 5 months and i love it!! Thanx

Nowso

better off conecting your laptop to ur tv especially if u have a hdmi slot on your laptop

Irish Kev

Guys

Anyone managed to get the PLTV working on 10east?

excollier

Can you enter BISS keys on this receiver?
I have it working fine for a friend on a TM5402

Irish Kev

excollier wrote: »

Can you enter BISS keys on this receiver?
I have it working fine for a friend on a TM5402

that part I have not figured out. I now you can load them via usb key but thats not worked.


ok found the edit option in the menu but still not working

and working :-)

iba

Hi

Easy question - which way does the CI card go in - chip facing up or chip facing down please?

Thanks

Iba

Nowso

down i had it the wrong way earlier

zg3409

iba wrote: »

which way does the CI card go in - chip facing up or chip facing down please?

Down