Zgemma H7s Guide

Evening all. I have a sab box upstairs but finding it difficult to figure out because I'm so used to the zgemma downstairs. Can any of you helpful people recommed a box like the zgemma please? I just want it for watching tv for a couple of hours at night. I don't need 2 sat feeds or recording. TIA :-)

Both saorview and sat are the main requirements thanks.

Thank you. Sounds like exactly what I am looking for.

Yes the EPG data would be less than 50Mb. You may also wish to store the PICON (small channel icons) folder on the USB as well. It too would be less than 50Mb

The amount of 8gb micro sticks i bought years ago and stuck in the back was handy.

You don’t say the image but for vix go file list, menu, settings and say, on, under the heading " enable automatic collections " with the comment " except in same named directory ", press green to save then have a look, it should show poirot in its own folder, say image if you come back.

Thanks swoofer. I was able to delete 14 episodes in one go!

When I hit File List on the remote I get this

Showing 1946 MB (78%) free discspace. So it would seem that the system can see the disc space but cannot get a route to the directory where the programmes are stored?

What you do is press the yellow button while in the directory as above, you should then get 4 options , no 3 should say media/hdd/movie, select that and you will see recordings etc exit out and next time when you press file list it will take you to that directory.

But may not solved the HDD problem. Is it an SSD and are you using an USB for the epg? Does the box get hot? What settings have you for the HDD?

Is the box the latest with HDD sticking out at rear?

So basically Storage is not showing on the Setup options and I think that nothing I do will work until it shows this option? Any ideas how I can make this happen? Or have I lost the internal drive altogether?

Go slow and see my Q's above then I'll guide you from there/

The box is an older one with an SSD. and it looks like this cannot be found after the system froze last night. When I press the yellow button I only get 2 options, 1 (Other…) , 2 Internal flash

1 gives me this screen but I think these are all in the RAM and not the SSD?

another shot from that menu try MEDIA/HDD/MOVIE and see if you can access that for your recordings.

Yes the box has lost the SSD so you have to turn off box and press that white button at rear. then open box to take out the SSD you will need to check the cable in the box as I have seen reports the cbale is too short. make sure ure the sata cable is fully seated on the board. then put back in ssd after you put cover back on, then power on with white button and wait.

BUT take a few pics of the inside of box as Andy on here has said capacitors swell.

If it does not recognise the SSD after the above its more than likely corrupt software. And I hope you have epg saved to SSD from the outset.

Have you only the one image on box?