Advertisement
Please note that it is not permitted to have referral links posted in your signature. Keep these links contained in the appropriate forum. Thank you.

https://www.boards.ie/discussion/2055940817/signature-rules
Help Keep Boards Alive. Support us by going ad free today. See here: https://subscriptions.boards.ie/.
If we do not hit our goal we will be forced to close the site.

Current status: https://keepboardsalive.com/

Annual subs are best for most impact. If you are still undecided on going Ad Free - you can also donate using the Paypal Donate option. All contribution helps. Thank you.
https://www.boards.ie/group/1878-subscribers-forum

Private Group for paid up members of Boards.ie. Join the club.

Tesla Model Y

1294295296297298300»

Comments

  • Registered Users, Registered Users 2, Paid Member Posts: 2,384 ✭✭✭Marty Bird


    Anyone with Junpier get water vapour in the light bar ? Mine has a good lot of it only seen it today. Requested a service from Tesla

    🌞6.02kWp⚡️3.01kWp South/East⚡️3.01kWp West



  • Registered Users, Registered Users 2 Posts: 30 Zizou


    Yes, noticed the same marty bird. Thanks for sharing.



  • Registered Users, Registered Users 2 Posts: 1,032 ✭✭✭JOL1


    I suspect its similar to what can appear in light unit that can develop a little condensation, particularly when changes in temperature and humidity can cause moisture to condense on the inside, especially after rain or a car wash,  high humidy after some rain ..and this usually dissapears. With the light units Tesla will usually say its within spec and unless pooling of water occurs it is performing as it should. My instinct is that this is what you are experiencing



  • Registered Users, Registered Users 2, Paid Member Posts: 2,384 ✭✭✭Marty Bird


    Thanks Jol I seen that in the manual.

    IMG_0012.png

    Its a good bit across the bar.

    🌞6.02kWp⚡️3.01kWp South/East⚡️3.01kWp West



  • Registered Users, Registered Users 2, Paid Member Posts: 4,931 ✭✭✭...Ghost...


    Checked my rear one, looks good. Need to check the front I suppose. Haven't noticed anything, but thanks for posting

    Stay Free



  • Advertisement
  • Registered Users, Registered Users 2 Posts: 8,341 ✭✭✭Grumpypants


    Looks like a Low Power mode was added last night. I noticed it this morning when i got in. Good to have a single setting to turn off all the things that can drain the battery. Sentry, USB ports, cabin overheat, preconditioning etc. without jumping through menus.



  • Registered Users, Registered Users 2, Paid Member Posts: 4,931 ✭✭✭...Ghost...


    I got that update a couple of weeks ago. It would be nice to have the option to have low power mode on and also be able to remotely activate normal mode for camera viewing. I do like to check the car if it’s in a dodgy area and there’s a bunch of scrawny teenagers hanging around when I park. I’ve used the remote function more than once to tell them to fcuk off away from the car. Priceless!

    Stay Free



  • Moderators, Society & Culture Moderators Posts: 41,165 Mod ✭✭✭✭Gumbo


    I thought sentry still worked with the low power mode on.



  • Registered Users, Registered Users 2, Paid Member Posts: 1,726 ✭✭✭rx8


    Has anyone had an issues with the tyre pressure monitoring system??

    Yesterday, the front left tyre showed low pressure. Lost about 6psi suddenly, checked for a nail or screw but nothing in it. I got the compressor on it and it showed about 41psi, so I put a small bit in. Drove around the block, but the sensor didn't move. I suspect that the sensor is dodgy now. Is this something I can report in the app?



  • Registered Users, Registered Users 2, Paid Member Posts: 21,323 ✭✭✭✭Cyrus


    ive found with the drop in temps that the tyres have all lost pressure, topped them all back up and drove around but took a little while for one of them to register the increased pressure,



  • Advertisement
  • Registered Users, Registered Users 2 Posts: 2,173 ✭✭✭innrain




  • Registered Users, Registered Users 2, Paid Member Posts: 1,726 ✭✭✭rx8


    Thanks for that. I'll let out a decent amount tomorrow and see if it picks it up, then bring it back up to the correct pressure.If it doesn't work I'll report it on the App.



  • Registered Users, Registered Users 2, Paid Member Posts: 4,931 ✭✭✭...Ghost...


    I'd just report it. Mine have all dropped by 4 PSI due to lower temps, but they all read. If one isn't performing, report. You can always cancel if it self-corrects.

    Stay Free



  • Registered Users, Registered Users 2 Posts: 105 ✭✭gallagheri


    Was looking to upgrade from my model 3 RWD to a EV SUV as we're expanding the family… I was almost sure I was not going to repeat brands but here we are… snatched this Model Y AWD with 1700km few weeks ago for 42K EUR. Maybe not everybody's preferred option but I wanted a LR to avoid losing range but also did not want to put a lot of money on top of my 2023 M3 RWD

    image.png


  • Moderators, Music Moderators Posts: 3,921 Mod ✭✭✭✭eeloe


    Picked yourself up a bargain there. i paid 38k for a RED AWD only 5 months ago, feel a bit sick now!



  • Moderators, Music Moderators Posts: 3,921 Mod ✭✭✭✭eeloe


    a 231 i meant to say



  • Registered Users, Registered Users 2, Paid Member Posts: 21,323 ✭✭✭✭Cyrus




  • Registered Users, Registered Users 2, Paid Member Posts: 4,931 ✭✭✭...Ghost...




  • Registered Users, Registered Users 2 Posts: 105 ✭✭gallagheri


    Thank you! This is exactly the reason I put a few extra thousand. All AWD around 30-35.000 KM 231 model were 35-38K. With the 'warrany' expiring in 2027 I thought maybe getting a certified one makes sense, and then it was basically brand new.



  • Registered Users, Registered Users 2, Paid Member Posts: 4,931 ✭✭✭...Ghost...


    Lads, I don't often visit the for sale section, so maybe others are the same. Minor intrusion here, but I have a brand new matt real carbon spoiler for the juniper listed there half price if interested. It was stuck in customs so I got another one. Won't fit old model.

    Stay Free



  • Advertisement
Advertisement