Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi all! We have been experiencing an issue on site where threads have been missing the latest postings. The platform host Vanilla are working on this issue. A workaround that has been used by some is to navigate back from 1 to 10+ pages to re-sync the thread and this will then show the latest posts. Thanks, Mike.
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Looking to borrow a G&G Delta Ring Tool.

  • 25-11-2014 10:13pm
    #1
    xxDSOFWxx
    Registered Users, Registered Users 2 Posts: 104 ✭✭


    I have a G&G CM16 Raider L, and I am doing some work on it ,...the part inside the barrel that is attached to the upper receiver,that holds the inner barrel,can only be taken off with a G&G DELTA RING TOOL.Has anyone in the Cork city area got one that I can borrow,because I have had no luck in finding one in Ireland.Open to recommendations as well.Please help???


Comments

  • #2
    brenak47
    Closed Accounts Posts: 1,446 ✭✭✭brenak47


    I used a long sniped nose pliers to open my raider one.


  • #3
    xxDSOFWxx
    Registered Users, Registered Users 2 Posts: 104 ✭✭xxDSOFWxx


    Thanks, works perfectly,another question can you install an aftermarket barrel with the raider????


  • #4
    brenak47
    Closed Accounts Posts: 1,446 ✭✭✭brenak47


    Ye thats what i did but depends on the barrel it might need a bit of modding to allow the end piece the rail screws into over it.


  • #5
    xxDSOFWxx
    Registered Users, Registered Users 2 Posts: 104 ✭✭xxDSOFWxx


    Thanks man you have been the most amazing help.Merry Christmas ;):)


  • #6
    brenak47
    Closed Accounts Posts: 1,446 ✭✭✭brenak47


    Not a bother man.Here is where i had to file down to get the ring to fit over but it took about ten mins to do.Again depends on the barrel u might be lucky with no mods. Happy xmas to u too.


  • Advertisement
Advertisement