Advertisement
Help Keep Boards Alive. Support us by going ad free today. See here: https://subscriptions.boards.ie/.
If we do not hit our goal we will be forced to close the site.

Current status: https://keepboardsalive.com/

Annual subs are best for most impact. If you are still undecided on going Ad Free - you can also donate using the Paypal Donate option. All contribution helps. Thank you.
https://www.boards.ie/group/1878-subscribers-forum

Private Group for paid up members of Boards.ie. Join the club.

Looking to borrow a G&G Delta Ring Tool.

  • 25-11-2014 10:13PM
    #1
    xxDSOFWxx
    Registered Users, Registered Users 2 Posts: 104 ✭✭


    I have a G&G CM16 Raider L, and I am doing some work on it ,...the part inside the barrel that is attached to the upper receiver,that holds the inner barrel,can only be taken off with a G&G DELTA RING TOOL.Has anyone in the Cork city area got one that I can borrow,because I have had no luck in finding one in Ireland.Open to recommendations as well.Please help???


Comments

  • #2
    brenak47
    Closed Accounts Posts: 1,446 ✭✭✭brenak47


    I used a long sniped nose pliers to open my raider one.


  • #3
    xxDSOFWxx
    Registered Users, Registered Users 2 Posts: 104 ✭✭xxDSOFWxx


    Thanks, works perfectly,another question can you install an aftermarket barrel with the raider????


  • #4
    brenak47
    Closed Accounts Posts: 1,446 ✭✭✭brenak47


    Ye thats what i did but depends on the barrel it might need a bit of modding to allow the end piece the rail screws into over it.


  • #5
    xxDSOFWxx
    Registered Users, Registered Users 2 Posts: 104 ✭✭xxDSOFWxx


    Thanks man you have been the most amazing help.Merry Christmas ;):)


  • #6
    brenak47
    Closed Accounts Posts: 1,446 ✭✭✭brenak47


    Not a bother man.Here is where i had to file down to get the ring to fit over but it took about ten mins to do.Again depends on the barrel u might be lucky with no mods. Happy xmas to u too.


  • Advertisement
Advertisement