hkc saab to menvier ts700 panel connections

johnj1 · 2014-08-21 22:43:18

Hi everyone,im want to replace an old bell box with a hkc sabb connected to a menvier ts700 panel.The old box was connected wrong as the tampers were not even used.The terminals on the menvier panel are TRG- ,STB- ,TR- ,H/O+ ,H/O- .Would be grateful if someone could tell me which terminals these go to in the hkc sabb,thanks

21-08-2014 11:43PM

#1

johnj1

Registered Users, Registered Users 2 Posts: 3 ✭

Join Date: February 2014

Posts: 1

Hi everyone,im want to replace an old bell box with a hkc sabb connected to a menvier ts700 panel.The old box was connected wrong as the tampers were not even used.The terminals on the menvier panel are TRG- ,STB- ,TR- ,H/O+ ,H/O- .Would be grateful if someone could tell me which terminals these go to in the hkc sabb,thanks

0

Comments

#2 23-08-2014 11:01PM

johnj1

Registered Users, Registered Users 2 Posts: 3 ✭

Join Date: February 2014

Posts: 1

Hi again,sorry had to give ye an akwkard one,thankfully it wasnt just me that couldnt figure it.this is how its done for anyone else that might need it.trg- to hkc bell- ,stb- to hkc strobe-,tr- to hkc tamper return,h/o+ to hkc bell+,h/0- to hkc hold off then link bell+ to strobe+ in hkc,thanks

0