Radiators not working after bleeding

Pressure is prob at zero. Top up the pressure

Go to the boiler and look at the pressure gauge. As above its dropped after bleeding. It should have a green zone on the face of it, between 1 and 1.5 bar. Find your filling loop it'll either be on a flexi or a lever under the boiler itself. Open this until the pressure rises to the required level. Post up a picture of the boiler and pipe work around it if you're unsure, but plenty of videos available on YouTube. You may need to bleed the rads one more time and increase pressure again.

Hey, mind letting us know? I've the same issue and not sure where the value is to add water. Cheers

Thats a valve for draining the system. Are there any more taps/valves in or around the bottom of the boiler?

The filling valve for mine was installed in the hotpress.

Have you a tank in the hotness?

My filling loop is in the hot press area so check that.

...

That's where it should fill from, if there isn't a blue handle on that I suspect its an external filling loop so follow that pipe as far as you can, check your hotpress/ airing cupboard around the hot water tank too.

Mine are also in Hot press with another gauge and levers either side to open and top up central heating.

https://www.boards.ie/discussion/2058271160/which-valve-will-repressurise-my-boiler#latest

OP's boiler is in the shed so may have been fed differently to norm, hence the post.

The one uninsulated pipe in the OP's first pic is the one i'd follow.

I was pointing at the CH return