Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi all! We have been experiencing an issue on site where threads have been missing the latest postings. The platform host Vanilla are working on this issue. A workaround that has been used by some is to navigate back from 1 to 10+ pages to re-sync the thread and this will then show the latest posts. Thanks, Mike.
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

Gap between press doors

  • 08-11-2018 5:50pm
    #1
    Salthillprom
    Registered Users Posts: 439 ✭✭


    Hi,
    I’m hoping someone can advise me please.
    I have a 3.7m wall. I want to put 6 no. 600mm width presses along it. This means I’ll have only 100mm to spare. Is that enough space?
    If I have each set of 2 doors closing flush with each other, I estimate that I could have a gap of 25mm at the start and between each set of 2 presses? Is that sufficient?
    Thanks


Comments

  • #2
    recipio
    Registered Users, Registered Users 2 Posts: 2,804 ✭✭✭recipio


    It depends on whether the doors are overlaid or insert. If they are overlaid you must deduct the overlay length ( usually 10 - 15 mm) across the width. If insert they will be flush to the face frame but allow about a 2 mm gap between the opening edges. When you have everything to hand to take measurements and draw it all out on graph paper to get it exactly right.


  • #3
    Salthillprom
    Registered Users Posts: 439 ✭✭Salthillprom


    recipio wrote: »
    It depends on whether the doors are overlaid or insert. If they are overlaid you must deduct the overlay length ( usually 10 - 15 mm) across the width. If insert they will be flush to the face frame but allow about a 2 mm gap between the opening edges. When you have everything to hand to take measurements and draw it all out on graph paper to get it exactly right.
    Thanks a million


Advertisement