Gap between press doors

Salthillprom · 08-11-2018 05:50PM #1

Hi,
I’m hoping someone can advise me please.
I have a 3.7m wall. I want to put 6 no. 600mm width presses along it. This means I’ll have only 100mm to spare. Is that enough space?
If I have each set of 2 doors closing flush with each other, I estimate that I could have a gap of 25mm at the start and between each set of 2 presses? Is that sufficient?
Thanks

recipio · 09-11-2018 11:57AM

It depends on whether the doors are overlaid or insert. If they are overlaid you must deduct the overlay length ( usually 10 - 15 mm) across the width. If insert they will be flush to the face frame but allow about a 2 mm gap between the opening edges. When you have everything to hand to take measurements and draw it all out on graph paper to get it exactly right.

Salthillprom · 14-11-2018 10:00AM

recipio wrote: »

It depends on whether the doors are overlaid or insert. If they are overlaid you must deduct the overlay length ( usually 10 - 15 mm) across the width. If insert they will be flush to the face frame but allow about a 2 mm gap between the opening edges. When you have everything to hand to take measurements and draw it all out on graph paper to get it exactly right.

Thanks a million

Gap between press doors

Comments