Advertisement
Help Keep Boards Alive. Support us by going ad free today. See here: https://subscriptions.boards.ie/.
https://www.boards.ie/group/1878-subscribers-forum

Private Group for paid up members of Boards.ie. Join the club.
Hi all, please see this major site announcement: https://www.boards.ie/discussion/2058427594/boards-ie-2026

Beer regulator gas fitting

  • 08-12-2013 11:34PM
    #1
    KeRbDoG
    Registered Users, Registered Users 2 Posts: 4,453 ✭✭✭


    Hi again,
    So I've called in a favour and now have all the fittings for a keg setup. Only small problem, the gas cylinder and the beer regulator gas fittings are different. Anyone have a keg setup and need a gas line/connector replaced?


Comments

  • #2
    Ronan cork
    Registered Users, Registered Users 2 Posts: 255 ✭✭Ronan cork


    KeRbDoG wrote: »
    Hi again,
    So I've called in a favour and now have all the fittings for a keg setup. Only small problem, the gas cylinder and the beer regulator gas fittings are different. Anyone have a keg setup and need a gas line/connector replaced?

    Do you mean your gas regulator doesn't fit your gas canister? Ie the part that screws into the canister?


  • #3
    eurokev
    Registered Users, Registered Users 2 Posts: 979 ✭✭✭eurokev


    local plumbing shop should be able to sort ya out, or at least point you in the right direction


  • #4
    Fuzzy Clam
    Closed Accounts Posts: 3,293 ✭✭✭Fuzzy Clam


    KeRbDoG wrote: »
    Hi again,
    So I've called in a favour and now have all the fittings for a keg setup. Only small problem, the gas cylinder and the beer regulator gas fittings are different. Anyone have a keg setup and need a gas line/connector replaced?

    Could you post a pic of the regulator fitting.
    You've might have an old Guninness reg which will be difficult to get gas for or you may have a co2 reg. Co2 regs are threaded on the inside of the fitting.
    Do not connect it to keg until the pressure has been set.


  • #5
    Fuzzy Clam
    Closed Accounts Posts: 3,293 ✭✭✭Fuzzy Clam


    KeRbDoG wrote: »
    Hi again,
    So I've called in a favour and now have all the fittings for a keg setup. Only small problem, the gas cylinder and the beer regulator gas fittings are different. Anyone have a keg setup and need a gas line/connector replaced?

    Could you post a pic of the regulator fitting.
    You've might have an old Guninness reg which will be difficult to get gas for or you may have a co2 reg. Co2 regs are threaded on the inside of the fitting.
    Do not connect it to keg until the pressure has been set.


Advertisement
Advertisement