Oil filter tool for 1.9TDI?

MAJJ · 25-11-2013 04:27PM #1

Hi Folks,

Car is VW 08 Touran 1.9TDI

Thought, this what I needed but it doesn't fit, just sits loosely on top, needs to be deeper.

This is what I bought
http://www.halfords.ie/webapp/wcs/stores/servlet/product_storeId_11101_catalogId_15551_productId_199193_langId_-1_categoryId_212616#tab3

Will upload photos filter later.

Thanks,
MAJJ

jimgoose · 25-11-2013 04:29PM

Is it a standard screw-on cylinder filter? A chain wrench should do the trick. Sealey do one for about a tenner in many motor factors.

MAJJ · 25-11-2013 04:39PM

Hiya Jim,

Man your quick

thanks

No it's a black plastic one. Kind of answered my own question when looking for an image, looks like this one. Wish I found this link before finding it in Halfords.

http://www.vwt4forum.co.uk/showthread.php?p=2166108

If I have a 32mm bit and extension bar in my halfords set that fits and I do it gently with a non torque wrench, should I be ok?

Thanks

jimgoose · 25-11-2013 04:47PM

MAJJ wrote: »

Hiya Jim,

Man your quick thanks

No it's a black plastic one. Kind of answered my own question when looking for an image, looks like this one. Wish I found this link before finding it in Halfords.

http://www.vwt4forum.co.uk/showthread.php?p=2166108

If I have a 32mm bit and extension bar in my halfords set that fits and I do it gently with a non torque wrench, should I be ok?

Thanks

Should be fine, I'd imagine. What is the torque spec on that thing?

MAJJ · 25-11-2013 04:50PM

jimgoose wrote: »

Should be fine, I'd imagine. What is the torque spec on that thing?

25 - 5 nm

Photo attached

jimgoose · 25-11-2013 04:50PM

MAJJ wrote: »

25 - 5 nm

What is that? 25 Nm or 5 Nm?

MAJJ · 25-11-2013 05:05PM

Not sure, I assumed it was a tolerance range, but I am clearly fresh to this. I just read it from the housing, photo now attached in post 5.

jimgoose · 25-11-2013 05:07PM

MAJJ wrote: »

Not sure, I assumed it was a tolerance range, but I am clearly fresh to this. I just read it from the housing, photo now attached in post 5.

Yes, I see. Use a 3/8'' ratchet, tighten until you feel resistance, then give it a 1/2-turn "nip". Sorted.

Oil filter tool for 1.9TDI?

Comments