Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Please note that it is not permitted to have referral links posted in your signature. Keep these links contained in the appropriate forum. Thank you.

https://www.boards.ie/discussion/2055940817/signature-rules
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

1.4 golf

  • 14-11-2013 9:37am
    #1
    Closed Accounts Posts: 499 ✭✭


    Fixed fan belt last week and also fitted a new thermostat to the car. Last few days it has been losing water and the fan is not kicking in the heat will only come on sometimes in the car. My friend says my headgasket is not gone ( he checked for the usual) found nothing wrong with it but thinks there is a leak in the radiator that could be causing it. there is red dried coolant on the radiator so makes me think he is right. Would this radiator leak cause the problems I am having


    timing belt was done 1 year ago
    fan belt last week
    thermostat last week


    thanks


Comments

  • Closed Accounts Posts: 499 ✭✭tankbarry


    anybody got opinions on this


  • Registered Users, Registered Users 2 Posts: 641 ✭✭✭kilianmanning


    Did you bleed the cooling system after changing the thermostat?


  • Closed Accounts Posts: 499 ✭✭tankbarry


    ye that was done. just checked the fan and it works if I manually turn it on it just wont turn on itself


  • Registered Users, Registered Users 2 Posts: 3,506 ✭✭✭Interslice


    tankbarry wrote: »
    ye that was done. just checked the fan and it works if I manually turn it on it just wont turn on itself


    A red salty residue is a sure sign of a leak. If you clean up the area, run the engine up to temp and have a look with a torch you might be able to pin point the leak. Could be a crack in the rad or dripping/running from one of the hose ends going into it.


  • Registered Users, Registered Users 2 Posts: 576 ✭✭✭dooroy


    Heater only working sometimes often indicates air in the system ;
    if coolant level drops enough (top of pipe in expansion tank becomes uncovered )before topping up air could find its way in .
    no output from heater can also indicate coolant level has dropped - does yours have a warning light for low coolant level ;
    Rad fan not coming on could be caused by (a) engine not being hot enough or (b) rad switch has failed .
    Why did you decide to change the thermostat - was there already a problem before it was changed ?


  • Advertisement
  • Closed Accounts Posts: 499 ✭✭tankbarry


    the thermostat blew.


  • Registered Users Posts: 114 ✭✭jordo76


    dose the temp gauge rise on the dash ??? have you checked the system is pressurized ??? i would think that there is a slight leak in the system or there is an air lock,

    try running the car to operating temp and open the expansion tank with a cloth over it making sure not to get burned by the escaping steam, if you get pressure release from there i would say its an air lock or just a bad thermostat and i know it might sound mad but is the thermostat the right way around ??


  • Registered Users, Registered Users 2 Posts: 576 ✭✭✭dooroy


    When you say the thermostat 'blew' do you mean it failed to open and caused engine to overheat ?
    If this was the case the head gasket could have suffered depending on how hot the engine got .
    If head gasket is leaking slightly it will cause the system to be pressurised more than normal and eventually something will 'give ' - burst hose , leak from a weak spot in the rad , leak from a joint etc.
    The cap on the expansion tank should allow the pressure to escape if it rises too much - but caps don't always do their job .
    A 'trick' I found worked on some cars with a similar problem in the past was :
    1) with cap tightened fully bring engine up to normal temp ;
    2) then loosen cap very slowly until you hear a faint hiss -( pressure
    escaping ) ; leave cap in this position ;
    3) then continue as normal - pressure will be released as it builds up
    and ,hopefully, before it causes problems .


  • Closed Accounts Posts: 499 ✭✭tankbarry


    wouldn't say blew but broke. The engine didn't overheat after it went I only drove it for 400 meters after it went.

    brought it to mechanic and he said the over heating after the fan belt was fixed was due to the thermostat being faulty he said it wouldn't open causing the car too overheat.


  • Registered Users, Registered Users 2 Posts: 576 ✭✭✭dooroy


    The engine didn't overheat after it went I only drove it for 400 meters after it went.

    How were you so sure of exactly when the thermostat failed - do you mean you only drove about 400 m after fan belt broke ?
    Was the car losing coolant before the fan belt broke and thermostat was replaced ?


  • Advertisement
  • Closed Accounts Posts: 499 ✭✭tankbarry


    Ye only drove 400 metres after fan belt broke. The thermostat broke before 2 weeks before the fan belt just never got it replaced. It was losing coolant but not much I put in the radiator leak stuff and that stopped the leak.


  • Registered Users Posts: 89 ✭✭Jack0106


    Hey guys, hope i found the right place to put this but i have a question. I have a 2001 mk4 golf (1.4) but it seems to be lacking a bit of power when it goes past 2500 rpm. I dont really mind when driving around my area, but when on the motorway it seems like some of those horses have turned to ponies. I know the car has only 75 bhp but come on.
    Is there anything i can do besides buying performance parts? or is there any problems that could be there?

    Any advice will be appreciated - Thanks


Advertisement