Aritech CS250 - FTC Reset

tedimc · 26-07-2013 01:41PM #1

Hi,

Does anyone know how to reset the failed to communicate error on the CS-250 panels?

I know I done it before, but can't remember what the exact steps were. The alarm is functioning fine, but just the flashing orange LED on the keypad is getting on my nerves.

Thanks.

altor · 26-07-2013 02:53PM

tedimc wrote: »

Hi,

Does anyone know how to reset the failed to communicate error on the CS-250 panels?

I know I done it before, but can't remember what the exact steps were. The alarm is functioning fine, but just the flashing orange LED on the keypad is getting on my nerves.

Thanks.

You just need to acknowledge the fault. Put in main user code, fail is indicated. Press NO then OK.

tedimc · 27-07-2013 10:35PM

Thanks Altor, I tried that already but it doesn't clear it.

I seem to recall something about clearing the numbers for the central stations and disconnecting the phone line.

Which I have all tried, but still no luck.

KoolKid · 27-07-2013 11:00PM

Is there no longer monitoring on the system?
If you delete the ARC phone numbers & account that might do it. If that doesn't then connect back the phone line & do a test call. After a successful call then delete the numbers.

altor · 29-07-2013 11:08PM

tedimc wrote: »

Thanks Altor, I tried that already but it doesn't clear it.

I seem to recall something about clearing the numbers for the central stations and disconnecting the phone line.

Which I have all tried, but still no luck.

Are you removing the numbers in engineering, is this a self monitored alarm, have you an active phone line on the system?

Aritech CS250 - FTC Reset

Comments