Advertisement
Help Keep Boards Alive. Support us by going ad free today. See here: https://subscriptions.boards.ie/.
https://www.boards.ie/group/1878-subscribers-forum

Private Group for paid up members of Boards.ie. Join the club.
Hi all, please see this major site announcement: https://www.boards.ie/discussion/2058427594/boards-ie-2026

Full auto on semi-problem

  • 05-11-2012 11:41PM
    #1
    Untamedlemon
    Registered Users, Registered Users 2 Posts: 529 ✭✭✭


    I have yet another but hopefully the final problem with my g&g combat machine carbine. When I go to semi the gun seems to fire normally sometimes but then it fires full auto while still on semi. I did some minor adjusting of the tappet plate because of my last problem but nothing major. It's not serious but I hope to sell it at Christmas to get a better gun so I want it in perfect condition :)


Comments

  • #2
    DeBurca
    Registered Users, Registered Users 2 Posts: 9,752 ✭✭✭DeBurca


    When you say "I did some minor adjusting of the tappet plate because of my last problem but nothing major" what exactly do you mean ???????


  • #3
    Untamedlemon
    Registered Users, Registered Users 2 Posts: 529 ✭✭✭Untamedlemon


    I mean I just lengthened the tappet plate spring about a mm just to fit it in place properly but that can always be recompressed together again.


  • #4
    Rooky1
    Registered Users, Registered Users 2 Posts: 3,534 ✭✭✭Rooky1


    Untamedlemon wrote: »
    I mean I just lengthened the tappet plate spring about a mm just to fit it in place properly but that can always be recompressed together again.

    Just to be clear for everyone I think you mean selector plate, rather than tappet plate.

    Is your selector plate binding on the inside of the receiver?
    I think Inari mentioned it on another of your threads.
    http://www.boards.ie/vbulletin/showpost.php?p=81541626&postcount=8


  • #5
    Untamedlemon
    Registered Users, Registered Users 2 Posts: 529 ✭✭✭Untamedlemon


    Sorry ye I meant selector plate-not thinking straight- it doesn't seem to be bending at all but I think it's just slipping slightly onto full auto which is just enough. Is there any way to tighten it up???????


  • #6
    Rooky1
    Registered Users, Registered Users 2 Posts: 3,534 ✭✭✭Rooky1


    As far as I'm aware there is no way of tightening the selector plate.
    Have you checked it for wear around where the selector switch engages the plate?
    If the AEG has had a good few bbs through it on semi, the cut off lever may have excessive wear on it!


  • Advertisement
  • #7
    Untamedlemon
    Registered Users, Registered Users 2 Posts: 529 ✭✭✭Untamedlemon


    Thanks Ill check that as soon as possible thanks for all the help


Advertisement
Advertisement