Advertisement
Help Keep Boards Alive. Support us by going ad free today. See here: https://subscriptions.boards.ie/.
https://www.boards.ie/group/1878-subscribers-forum

Private Group for paid up members of Boards.ie. Join the club.
Hi all, please see this major site announcement: https://www.boards.ie/discussion/2058427594/boards-ie-2026

help for technomate tm6900hd combo

  • 10-12-2011 05:22PM
    #1
    fastken
    Registered Users, Registered Users 2 Posts: 3 ✭


    Hi, i have a dead tm 6900hd combo receiver due to the following.
    Receiver working fine until i retuned my motorised dish after a windy day.
    I was turning the dish manually to peak the signals on the meter, when i went inside to check the signal on the receiver i found it dead. there was no light on the front led read out . disconnected all the cables and then only reconnected the mains one, but nothing happened, still dead.
    My question, is there anything that can be done other than discarding it.
    Please help,
    fastken


Comments

  • #2
    byte
    Moderators, Regional North West Moderators, Paid Member Posts: 19,243 Mod ✭✭✭✭byte
    byte


    Check the fuses? Especially maybe the internal PSU fuse.

    Else, it is possibly a component fault on the internal powersupply. You'd need a competent technician to repair.


  • #3
    fastken
    Registered Users, Registered Users 2 Posts: 3 ✭fastken


    Hi, thanks i have checked the fuses all ok, some how if anyone knows were we could get a power supply board for this machine.
    Fasken


  • #4
    garrycann78
    Registered Users, Registered Users 2 Posts: 147 ✭✭garrycann78


    fastken wrote: »
    Hi, thanks i have checked the fuses all ok, some how if anyone knows were we could get a power supply board for this machine.
    Fasken

    open up the receiver. with psu's its more than likely the capacitor that has blown. the cap of the capacitor will be bulging or slightly leaking.


Advertisement
Advertisement