Projector going to standby after power-up

dodzy · 2010-06-13 07:19:12

Have just got a Panasonic PTAE700 from a friend. Powers up but then immediately goes into standby. Have tried searching for specific results but no answer. Is the "standby feature" a normal mode to indicate a fault ? New to the whole projector thingy but would like to incorporate in into attic conversion shuold I ever get…

13-06-2010 08:19AM

#1

dodzy

Registered Users, Registered Users 2 Posts: 10,493 ✭✭✭✭

Join Date: September 2007

Posts: 10051

Have just got a Panasonic PTAE700 from a friend. Powers up but then immediately goes into standby. Have tried searching for specific results but no answer. Is the "standby feature" a normal mode to indicate a fault ?

New to the whole projector thingy but would like to incorporate in into attic conversion shuold I ever get around to it.

0

Comments

#2 21-06-2010 02:54PM

Tea drinker

Registered Users, Registered Users 2 Posts: 2,818 ✭✭✭

Join Date: March 2003

Posts: 2673

Don't know much, but is it possible it is not receiving anything, a cable fault maybe?

0
#3 22-06-2010 10:58PM

lar77

Registered Users, Registered Users 2 Posts: 189 ✭✭

Join Date: March 2010

Posts: 165

I'm assuming it's not new. How many hours has the bulb run for? The panasonic projectors go into stand by or switch off once the bulb is over a pre-determined amount of hours ....... as far as I know

0