Dynacord PM 2600 Bass panned one side

JJSolutions · 27-03-2010 09:24AM #1

Hi,

has anyone ever experienced anything like this:

My Dynacord Poweramp seems to be running tops fine but the bins are "panned" all to one side, when the desk is panned centrally i can hear bins and tops, but pan to one side one side of tops are on ( as expected ) but the bins are either gone or fully one depending on the side you pan to.

i have tried other desks leads etc - it must be the amp, no warning lights are on but seems one side of the amp handling bins is powering both sides

any help is welcomed.

darrenw5094 · 29-03-2010 10:16PM

JJSolutions wrote: »

Hi,

has anyone ever experienced anything like this:

My Dynacord Poweramp seems to be running tops fine but the bins are "panned" all to one side, when the desk is panned centrally i can hear bins and tops, but pan to one side one side of tops are on ( as expected ) but the bins are either gone or fully one depending on the side you pan to.

i have tried other desks leads etc - it must be the amp, no warning lights are on but seems one side of the amp handling bins is powering both sides

any help is welcomed.

I assume that you are going from amp into bins, and then bin up to top.
If so, obviously the crossover in the bin is fine because the sound is going to the top. The problem might in the bin that is not working.

Or you have some high pass filter on from the desk by mistake.

DogfoxCork · 15-10-2013 11:03PM

was this ever fixed? having a similar problem with ours, its going for a service anyway but would still be good to know what (if any) solutions fixed yours?

Dynacord PM 2600 Bass panned one side

Comments