Advertisement
Help Keep Boards Alive. Support us by going ad free today. See here: https://subscriptions.boards.ie/.
https://www.boards.ie/group/1878-subscribers-forum

Private Group for paid up members of Boards.ie. Join the club.
Hi all, please see this major site announcement: https://www.boards.ie/discussion/2058427594/boards-ie-2026

Fixed shower arm for concealed shower valve

  • 22-02-2010 04:14PM
    #1
    Registered Users, Registered Users 2 Posts: 27,518 ✭✭✭✭


    Hi all,

    Im trying to figure out how Im supposed to fit the following shower arm.
    Shower Arm Spec

    Basically its a shower arm threaded at both ends.
    One end for the shower head and the other for the pipe. There is also a single screw on cover plate to conceal the hole.

    But for the life of me I cant see what holds it in place?

    I could fix the pipe to the wall behind with a 90% bend with wall bracket built in, but then if the wall +tiles are deeper than the shower arm I'm screwed.

    The other arms Ive seen have a back nut that screws on so the wall is between the back nut and the cover plate, but again how do you fit this if its inside the wall?!

    Any ideas? :o


Comments

  • Registered Users, Registered Users 2 Posts: 21,873 ✭✭✭✭cnocbui


    There is a right angle fitting I got which had a 3/4" compression fitting on one side and a threaded flange on the other, that the shower arm screwed into. In addition, there were two lugs with holes so this fitting could be securely screwed to the wall.

    Worked a treat.


  • Registered Users, Registered Users 2 Posts: 10,262 ✭✭✭✭Joey the lips


    cnocbui wrote: »
    There is a right angle fitting I got which had a 3/4" compression fitting on one side and a threaded flange on the other, that the shower arm screwed into. In addition, there were two lugs with holes so this fitting could be securely screwed to the wall.

    Worked a treat.

    Its called a 317w wall plate ;) and it should be 1/2" as this is the arm size


Advertisement
Advertisement