Cummins engine parts/info required

Humding · 11-12-2009 11:02PM #1

I am looking for info on Cummins engines fitted to diggers and other plant (1990's - early 00's). Its the 6BT 6 Cylinder model (identified by 6 seperate rocker covers and the inlet manifold is part of the head). I have one of these engines out of a DAF 45 but need to convert the spec of it. I have been told they have been fitted in diggers so any help would be appreciated. I require the following parts or alternatively an engine number so I can order then from Cummins. First option above would be preferred

Oil pick up (turning the sump so existing one won't do) The one I want has the deep part of the sump at the flywheel end
Short dipstick and tube
Oil filler & cap

Slidey · 12-12-2009 12:33AM

Have you any idea what machines they were fitted to?

I know the engine but only from the DAFs. If you could tell me what make/model of machine they were in I might be able to find the bits for you

jetfiremuck · 12-12-2009 04:14PM

You might check the isuzu 6 cyl truck engines. I think some parts interchange.

Humding · 12-12-2009 09:45PM

Slidey wrote: »

Have you any idea what machines they were fitted to?

I know the engine but only from the DAFs. If you could tell me what make/model of machine they were in I might be able to find the bits for you

No, I have no firm info on what they were fitted to which is why I was asking . Have been told they may be fitted to Komatsu, Hyundai, Daewoo and Case.

Slidey · 12-12-2009 09:54PM

You will also need to change the injector pump as the pump will be set up differently for a truck to a machine

Humding · 13-12-2009 08:29PM

The engine is going into a road going vehicle so pump is OK. The only reason I was asking about plant is that I am told they would have the correct sump orientation I'm looking for and possibly a short dipstick rather than the 5 or 6 foot long one on the DAF

Cummins engine parts/info required

Comments