Advertisement
Help Keep Boards Alive. Support us by going ad free today. See here: https://subscriptions.boards.ie/.
https://www.boards.ie/group/1878-subscribers-forum

Private Group for paid up members of Boards.ie. Join the club.
Hi all, please see this major site announcement: https://www.boards.ie/discussion/2058427594/boards-ie-2026

Aritech CS-250 series issue

  • 18-09-2009 12:47PM
    #1
    Bull76
    Registered Users, Registered Users 2 Posts: 289 ✭✭


    Hi Folks,

    Have moved into a new house to us, previous owners had let an issue arise with the alarm system. It had a battery fault, so needed replacing. Didn't get around to it and the ESB have cut power to oue estate for over 8 hours.
    The power is back and the display is stating " Please Install NO + #". Have headed off and got a replacement battery, old one was only at 7.2volts. Installed a new 12V 7.2aH battery.

    Now how do I go about resetting the unit? I don't have the engineers code for the unit and the previous owners were very slow in giving us the code they had so we could test the system out.
    So do I need to get an alarm installer in to rectify this? Any ideas welcome.

    Regards,
    Anthony.


Comments

  • #2
    KoolKid
    Moderators, Home & Garden Moderators, Technology & Internet Moderators Posts: 24,790 Mod ✭✭✭✭KoolKid


    So when you install with NO + # what is happening?
    There is no factory link on the CS250 but most installers would have a flash card with the latest software version to flash it with.


  • #3
    Bull76
    Registered Users, Registered Users 2 Posts: 289 ✭✭Bull76


    Hi,

    The display is flashing " Please install NO + #". Haven't done anything or tried to do anything other than replace the faulty Battery. So it needs to be re-flashed?

    Regards,
    Anthony.


  • #4
    altor
    Registered Users, Registered Users 2 Posts: 12,094 ✭✭✭✭altor


    Bull76 wrote: »
    Hi,

    The display is flashing " Please install NO + #". Haven't done anything or tried to do anything other than replace the faulty Battery. So it needs to be re-flashed?

    Regards,
    Anthony.

    Hi Anthony,
    The system is asking this because it has being powered off and the system needs to be initialized e.g system country, time and date. press the no plus # together should get you in to set the country, time and date.
    Hope this helps...

    www.altor.ie



  • #5
    KoolKid
    Moderators, Home & Garden Moderators, Technology & Internet Moderators Posts: 24,790 Mod ✭✭✭✭KoolKid


    As Altor said thats all it needs to get it going. If you want to deafult it then it needs to be flashed.


  • #6
    Bull76
    Registered Users, Registered Users 2 Posts: 289 ✭✭Bull76


    Thanks Altor,

    Folks, I can high recommend Altor for any of your alarm issue's. Had him call out and rectify our alarm. Very professional in his work. Also a very person also.

    Regards,
    Anthony.


  • Advertisement
Advertisement
Advertisement