Mounting E-flow tag

dceire · 22-12-2008 05:20PM #1

I had to take down my eflow tag because it was interfering with my mirror & subsequently the adhesive on the tag holder is useless. I dont know what the hell i could use to reattach it, any suggestions?

L1011 · 22-12-2008 05:57PM

double sided sticky tape over the existing adhesive?

I suspect eFlow will send you another one if you ask nicely - I got a replacement from eTrip due to putting it on backwards (:o) and another when I got a new car; both FOC.

rebel.ranter · 22-12-2008 08:28PM

Dual sticky mounting tape is what you are after here. It is a bit spongy so should make a better bond with the windscreen.

dceire · 22-12-2008 11:22PM

rebel.ranter wrote: »

Dual sticky mounting tape is what you are after here. It is a bit spongy so should make a better bond with the windscreen.

And where would one acquire such dual sticky mounting tape?

crosstownk · 22-12-2008 11:36PM

Get some of that Loctite stuff that's used for fixing rear view mirrors to windscreens. Most motor factors have it.

dceire · 22-12-2008 11:44PM

The only thing is that I'm hoping to use something that will keep it in place but isn't too permanent because there's a few chips in the windscreen and sometime in the not so distant future I hope to have it replaced.

Mounting E-flow tag

Comments