HKC Alarm - programming a Part Set

redman · 07-06-2006 08:42PM #1

Anyone know how to progam the Part Set B on a Securewatch panel?
I want to create a setting that inhibits some zones.

When I go into the service menu and select default panel it asks do I wish to load defaults? Which I don't becase I have Part Set A already set up on the system

Welcome any advice?

Redman

Spocker · 08-06-2006 12:20AM

I have the manual for this - will dig it out for you tomorrow evening if you don't have an answer by then

Jnealon · 08-06-2006 08:20AM

Go in to zone menu hit yes then zone options hit yes then choose zone you want to set up for part guard hit yes then go to the partguard a (0#7) or partguard b(0#8) option and enable which ever partguard you want the zone to be turned off for.
If you choose any of the domestic defaults in the service menu zone 4 is turned off for PG

johnnyrotten · 08-06-2006 10:26AM

On a side note:
Anyone know how to change the alarm code for this panel

redman · 08-06-2006 02:06PM

Jnealon wrote:

Go in to zone menu hit yes then zone options hit yes then choose zone you want to set up for part guard hit yes then go to the partguard a (0#7) or partguard b(0#8) option and enable which ever partguard you want the zone to be turned off for.
If you choose any of the domestic defaults in the service menu zone 4 is turned off for PG

Thanks, I'll try that tonight

Redman

redman · 08-06-2006 08:54PM

That worked - many thanks!

HKC Alarm - programming a Part Set

Comments