Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie

Cannot add wireless HKC PIR sensor

  • 09-03-2025 04:07PM
    #1
    SD_DRACULA
    Registered Users, Registered Users 2 Posts: 2,605 ✭✭✭


    I have a HKC 1070 panel and bought a new wireless PIR sensor, followed the manual to add it from engineer menu, Devices Menu → RF Devices Menu → Add &ID RF Devices → Add&ID:RF Zones

    This scans indefinitely and just doesn't find it, stuck on 000 and it should go to 001 once found.

    image.png

    I bought a new battery to be sure the one it came with wasn't drained but the same. I do see it flash a few times when inserting the battery but that's it.

    Any ideas?

    image.png


Comments

  • #2
    Jnealon
    Registered Users, Registered Users 2 Posts: 2,086 ✭✭✭Jnealon


    Did you buy it locally or from the UK. UK and IE parts are not comparable with each other.

    I didn't think they shipped with Panasonic batteries, usually Duracell



  • #3
    SD_DRACULA
    Registered Users, Registered Users 2 Posts: 2,605 ✭✭✭SD_DRACULA


    The panasonic was me trying out a new battery but I think you might be right with the UK/IE bit.

    Sensor was bought locally but I can see on the 1070 board it has UK so that may be it.

    Is it the same for wired PIR sensor or that should work fine?

    Post edited by SD_DRACULA on


  • #4
    Jnealon
    Registered Users, Registered Users 2 Posts: 2,086 ✭✭✭Jnealon


    Wired sensors will be fine, it's mainly wireless devices, keypads, expanders etc



  • #5
    SD_DRACULA
    Registered Users, Registered Users 2 Posts: 2,605 ✭✭✭SD_DRACULA


    https://www.boards.ie/discussion/comment/123256369#Comment_123256369

    Guess I need to buy one from UK ebay if I want it to work with my panel.



Advertisement