Advertisement
Help Keep Boards Alive. Support us by going ad free today. See here: https://subscriptions.boards.ie/.
https://www.boards.ie/group/1878-subscribers-forum

Private Group for paid up members of Boards.ie. Join the club.
Hi all, please see this major site announcement: https://www.boards.ie/discussion/2058427594/boards-ie-2026

Stripping zetor mower

  • 25-04-2023 05:47PM
    #1
    irishguy19772
    Registered Users, Registered Users 2 Posts: 523 ✭✭✭


    2 questions. Trying to replace drums on my own zetor 165 mower with a secondhand one I got


    What is best way of removing the bolt in pic attached. Only one I couldn't get out. All worn and can't catch with Allan key.

    20230425_173758.jpg


    Second question is how to get the drum out? Not sure what is holding it

    20230425_174104 (1).jpg




Comments

  • #2
    893bet
    Registered Users, Registered Users 2, Paid Member Posts: 10,642 ✭✭✭✭893bet


    I would hammer and chisel. Get a new nut and don’t be lazy putting back on old one.



  • #3
    Suckler
    Registered Users, Registered Users 2 Posts: 3,534 ✭✭✭Suckler


    For the first one - try these - although the hole looks like it might be too big. Otherwise tack on a nut.

    https://www.toolfix.ie/p/toptul-5pcs-screw-extractor-set/qjgaw0501



  • #4
    caesar
    Registered Users, Registered Users 2 Posts: 753 ✭✭✭caesar


    Left-hand drill bit(s) might also be handy for the first.



  • #5
    ARGINITE
    Registered Users, Registered Users 2 Posts: 2,717 ✭✭✭ARGINITE


    Clean it up and weld a nut to the top of it, added benefit of the heat from welding to loosen things up.



  • #6
    RockOrBog
    Registered Users, Registered Users 2 Posts: 573 ✭✭✭RockOrBog


    Put a good washer on top of it and fill the hole with weld to stick it to just the bolt, Then weld a nut to the washer.



  • Advertisement
Advertisement
Advertisement