Super B Chain Keeper Tool TB-CH10

Carnmore · 2023-02-24 17:58:34

Could anyone explain the correct assembly for this with pictures/diagrams? The issues I experienced are: 1. The orange wheel was clamped and not spinning 2. The alignment was wrong (the chain was jumping inwards off the jockey wheel) 3. The chain was rubbing along the top of the chain stay. The bike It is being used on is…

24-02-2023 06:58PM

#1

Carnmore

Registered Users, Registered Users 2 Posts: 410 ✭✭

Join Date: August 2016

Posts: 249

Could anyone explain the correct assembly for this with pictures/diagrams?
The issues I experienced are:
1. The orange wheel was clamped and not spinning
2. The alignment was wrong (the chain was jumping inwards off the jockey wheel)
3. The chain was rubbing along the top of the chain stay.
The bike It is being used on is a Cube SL Road Pro with quick release spindle.
Thank you in advance!

0

Comments

#2 24-02-2023 08:08PM

Mefistofelino

Registered Users, Registered Users 2 Posts: 2,386 ✭✭✭

Join Date: September 2012

Posts: 2370

Did you install it with the qr lever outside the frame? Some chain keepers like the Park Tool one have the lever outside the frame, as you would have a wheel QR. Others like the SuperB or the Lifeline have the lever inside.

I suspect that may be the issue. Installing it the other way round will clamp the pulley
The other issues are probably just a case of putting the rear mech in the right gear for the pulley position.

1