EV Charger connection from the meter box

Here's a pic of my meter box installation which was done last Monday. Zappi is just to the right on the wall with an isolator switch. I have a day night meter and the small fuseboard box replaced a smaller one that was there already. Neat install, all compliant.

I can't say that means a lot to me, is it something to be concerned about?

Isolation switch is outside on the wall beside the charger

I didn't think they were allowing EV chargers to be wired from meter cabinets now.

Last inspection I had inspector told me ESB networks now do not allow it to be supplied from the meter cabinet.

Last inspection was September

Multiple breaches of regulations

1 it’s not permitted in Esb meter box since march 2022

2 it requires double pole isolation on distribution board

3 it requires single pole isolation for sub board in house (may be there but I can’t make it out)

4 it requires surge protection

5 no gland on cable at bottom (minor issue but affects the ip 55 rating)

A 7 module enclosure is the minimum required to fit all the associated tripswitchs.That’s why it’s not permitted inside a meter cabinet as it’s too big for esbn permissible measurements(180mmx225mm) .It can go outside the meter cabinet,adjacent to it

page 17/18 of the link deal specifically with it

https://safeelectric.ie/contractors/wp-content/uploads/sites/2/2022/08/April2022NewsletterSafeElec-Final.pdf

Yes