Removing disconnected points from my set up

spose · 07-04-2022 04:18PM #1

We recently did some work in the house and in the process took out/lost a PIR and a window contact from our set up. I want to remove those 2 points now from my set up so I can just set the alarm as normal. Unfortunately the installer is no longer in business so can’t go back to them. Those I have contacted will only do it if they can replace all the hardware inside and out which seems overkill. I can’t see a model number on the panel or inside if I take the cover off. I know the point IDs. Is there a straightforward way to permanently knock these points off my set up? Thanks

altor · 07-04-2022 07:51PM

https://www.boards.ie/discussion/2058240744/removing-disconnected-points-from-my-set-up

It can be done buy may entail defaulting the system to factory settings if back door code has been changed or the system is a 6/10 panel.

Point ID sensors are giving an ID by the system so need to be deleted to be removed from the system.

spose · 11-04-2022 08:52PM

Thanks. Is there a physical way to do that reset without the access? I can’t see any specific model info other than the secure watch on the front. If I reset it, is it straightforward enough to set it back up without the disconnected units

altor · 13-04-2022 06:30PM

https://www.boards.ie/discussion/comment/118913057#Comment_118913057

To disconnect you need engineer access to the alarm as once the sensor is identified to the system it needs to be deleted in engineer mode.

A full default means a full enrollment of the sensors back to the system, less the ones you are removing.

Removing disconnected points from my set up

Comments