Buildup in kettle with water softener

TheHulk · 29-01-2022 08:03AM #1

I live in an area with notoriously hard water so I got a water softener installed about a year ago. It is a twin type so no hard water should enter the system.

A few weeks back I desccaled my kettle because it had some limescale remaining since before the softener was installed. Yesterday I noticed that there was some type of build-up on the kettle again.

Could this be an issue with my softener, or is there another explanation?

Any advice appreciated.

shane b · 29-01-2022 08:54PM

Silly question, does it have enough salt in the tank?

TheHulk · 30-01-2022 06:19AM

Yep, 2 blocks, always kept topped up

dathi · 31-01-2022 09:20AM

the cold water supply to the kitchen sink is usually not connected to the water softener as per building regs

TheHulk · 01-02-2022 05:29PM

https://www.boards.ie/discussion/comment/118558132#Comment_118558132

It is in this case Dathi

DamoNolan · 14-02-2022 08:46PM

Can I ask what sort of water softener you have..im looking at getting one installed and seen ones that go under the sink which would be what I would like to go for..are they worth the money in yiur experience.

TheHulk · 23-03-2022 09:29AM

https://www.boards.ie/discussion/comment/118631608#Comment_118631608

Got the issue resolved so now I can reply! Yes worth it if you have bad limescale in your area. Was a necessity for me as it would have caused damage to heating and appliances.

10-10-20 · 23-03-2022 09:37AM

What was the cause in the end, OP?

TheHulk · 23-03-2022 11:29AM

https://www.boards.ie/discussion/comment/118822352#Comment_118822352

Faulty unit essentially. Lots of things were tried but it had to be replaced in the end. Never got a clear root cause.

It was using salt all along but not doing anything.

Buildup in kettle with water softener

Comments