HKC Quantum 70 RF battery low

Castlehills · 2022-01-10 14:16:51

Hi, I need some assistance in replacing a battery in rf sensor, I’m assuming these are windows/doors sensor. The error message on my control panel reads “ RF battery low “ but it doesn’t specify which one. Do I need to do anything with the engineer’s code if i was to replace batteries in all 8 sensors? Much appreciated

10-01-2022 03:16PM

#1

Castlehills

Registered Users, Registered Users 2 Posts: 9 ✭

Join Date: November 2017

Posts: 8

Hi, I need some assistance in replacing a battery in rf sensor, I’m assuming these are windows/doors sensor. The error message on my control panel reads “ RF battery low “ but it doesn’t specify which one. Do I need to do anything with the engineer’s code if i was to replace batteries in all 8 sensors? Much appreciated

0

Comments

#2 10-01-2022 07:44PM

altor

Registered Users, Registered Users 2 Posts: 12,094 ✭✭✭✭

Join Date: May 2009

Posts: 12044

https://www.boards.ie/discussion/2058227068/hkc-quantum-70-rf-battery-low

If you have the engineer code you can check the log to see what the low battery is.
If you have a wire free external bell then this would be the place to start if system is over 3 years old.
When changing the batteries put the system into engineer mode.

www.altor.ie

0