Advertisement
Please note that it is not permitted to have referral links posted in your signature. Keep these links contained in the appropriate forum. Thank you.

https://www.boards.ie/discussion/2055940817/signature-rules
Help Keep Boards Alive. Support us by going ad free today. See here: https://subscriptions.boards.ie/.
https://www.boards.ie/group/1878-subscribers-forum

Private Group for paid up members of Boards.ie. Join the club.
Hi all, please see this major site announcement: https://www.boards.ie/discussion/2058427594/boards-ie-2026

2014 Ford Ranger DPF issue

  • 30-10-2021 10:19PM
    #1
    Registered Users, Registered Users 2 Posts: 2,409 ✭✭✭


    Hi All,

    So I recently had my ranger go into limp mode and when I read the codes via my OBD ELM 327 I get the attached codes.

    I removed my DPF and brought it to a local Dpf cleaning centre and it came back as good as new.

    I also replaced the exhaust sensor in the Dpf centre.

    I removed the vaporiser and found it to be blocked, I cleared this and refitted it.

    When I clear the codes with the OBD, it immediately goes back to limp mode and the same codes appear.

    With accelerator fully pressed I'm not getting over 2500 rpm.

    I can't force a regen as I don't have the elm lead for my laptop, I have it being delivered and I'll download forscan then.

    Would anyone have any idea as to what the problem could still be ?

    Does it need a regen before the codes completely clear?

    I'm worried about putting it into a regen if there is some blockage still present which could cause a fire risk.

    Thanks in advance.



Comments

Advertisement
Advertisement