WTD: Topeak Joe Blow Pump Connection

pprendeville · 22-06-2021 08:32AM #1

Not sure what has happened my pump but when I inflate all the air leaks out. Anyone got an old head like shown? I have replacement bungs and tried replacing them but it didnt solve the issue.
[IMG]http://[/img]

http://

It would be this one I need.
https://georgehallscycles.co.uk/epages/726cf202-99f3-48ca-823d-63e916b367ab.sf/en_GB/?ObjectPath=/Shops/726cf202-99f3-48ca-823d-63e916b367ab/Products/8009

eeeee · 22-06-2021 09:29AM

I have one.

I also had the same problem and it was the little knob on the bottom between where your feet go that was unscrewed, screwed it back in and no leaks!

Give me a shout if you still need it.

pprendeville · 25-06-2021 02:24PM

eeeee wrote: »

I have one.

I also had the same problem and it was the little knob on the bottom between where your feet go that was unscrewed, screwed it back in and no leaks!

Give me a shout if you still need it.

Any chance you could throw up a photo?

eeeee · 25-06-2021 05:09PM

pprendeville wrote: »

Any chance you could throw up a photo?

I'll pop one up this eve!

eeeee · 25-06-2021 09:21PM

This was the nozzle that was too open for me, I bought 2 heads to cure it, and it was just this wee button all the time :facepalm:

6034073

eeeee · 25-06-2021 09:22PM

I'm out to post tomorrow, I can hold off and refund you if that fixes your problem!

pprendeville · 01-12-2021 01:25AM

Looking for one of these as the thread on the one I got was too small. Needs to be the wider thread as per the link.

https://georgehallscycles.co.uk/epages/726cf202-99f3-48ca-823d-63e916b367ab.sf/en_GB/?ObjectPath=/Shops/726cf202-99f3-48ca-823d-63e916b367ab/Products/8009

Paul Kiernan · 01-12-2021 10:38AM

FWIW I had a problem with the head leaking and fixed it by removing the yellow handle and carefully refitting it. There are only so many places where it can leak.

Obviously if something is broken it's a different matter! I'll get my coat!

WTD: Topeak Joe Blow Pump Connection

Comments