Plexiglass/perspex & piping

Sir Random · 11-10-2003 02:15AM #1

Does anyone know a good place to get plexiglass? I know I can get 8'x4' sheets from a glazier but I'm wondering if anywhere does smaller amounts and tinted if possible?
Also, the piping for covering up cut edges? I tried an auto parts dealer but they only had it in precut sizes which works out as dear as buying a "window kit". I'd like to get a whole roll of it so I can experiment, and ideas where to look?

Winters · 11-10-2003 12:36PM

Originally posted by Sir Random
Also, the piping for covering up cut edges? I tried an auto parts dealer but they only had it in precut sizes which works out as dear as buying a "window kit". I'd like to get a whole roll of it so I can experiment, and ideas where to look?

You can use electrical cable for this. Make a slit down one side so you can open it up and take out the cables inside. Then you can run it around the sharp edge you cut. Easy

Place the perspex then behind that, i think.

Sir Random · 11-10-2003 04:03PM

Thanks Winters, I tried something similar by cutting into a long strip of rubber with a stanley, but it was very hard to keep the cut straight. I have some rolls of co-ax cable which I might try but they're brown and white

. PVC cable is very expensive to buy by the roll.

CombatCow · 12-10-2003 02:00PM

If ya want that rubber trim,go to a car accesory shop and get what they call door protector strips,they are slim rubber strips and work very nicely around a window,btw those window kits are good but are extreamly hard to install,you need two people for it, you can also get perspex in B&Q liffy valley in large sheets.

CombatCow

Plexiglass/perspex & piping

Comments