Advertisement
Help Keep Boards Alive. Support us by going ad free today. See here: https://subscriptions.boards.ie/.
https://www.boards.ie/group/1878-subscribers-forum

Private Group for paid up members of Boards.ie. Join the club.
Hi all, please see this major site announcement: https://www.boards.ie/discussion/2058427594/boards-ie-2026

Immersion heater on timer

  • 02-06-2018 11:18PM
    #1
    cj2007
    Registered Users, Registered Users 2 Posts: 91 ✭✭


    We recently had a timer added to our immersion to heat the water so have two panels- one with bath sink and on off switches then the timer.

    I want to heat the water between 6-8am so have set the time to this but do I also need to switch the other panel to on for it to work? I’m worried that putting the switch to on will mean it will be on all the time.

    Thanks in advance!


Comments

  • #2
    Wearb
    Moderators, Home & Garden Moderators Posts: 6,707 Mod ✭✭✭✭Wearb


    Chose whether you want lots of hot water (bath) or less (sink) then set your timer. You will only be heating the water for the time you set on the timer. Keep reducing the timer period until you get to where a certain time will give you the amount of hot water you need. Note that this will be longer in the winter than summer (due to difference in starting temperature.


  • #3
    cj2007
    Registered Users, Registered Users 2 Posts: 91 ✭✭cj2007


    Ok so should I leave the other switch beside the sink and bath to off or on?

    I left it at off and switched the timer on for 2 hours this morning on sink and we don’t have any hot water.


    Thanks for your help


  • #4
    colm_mcm
    Registered Users, Registered Users 2 Posts: 73,328 ✭✭✭✭colm_mcm


    You need to leave the old on/off switch on.


  • #5
    cj2007
    Registered Users, Registered Users 2 Posts: 91 ✭✭cj2007


    Great thanks so the timer will override the on off switch and I don’t have to turn it off?

    Sorry for what seem like silly questions we had a totally different timer in our apartment that didn’t have on off as well as timer


  • #6
    Wearb
    Moderators, Home & Garden Moderators Posts: 6,707 Mod ✭✭✭✭Wearb


    There could be a few different ways that the timer is wired. If it’s wired at the supply side of you existing bath/sink switch then advice above works.
    If (for some unknown reason) the timer is wired to the output side of that switch, three or maybe even more different configurations are possible.

    Leave the existing switch on and timer off and then check that the top of the cylinder isn’t getting hot. Do this with bath and then sink, about half an hour each should test it. If not heating during this test, then you are good to go with the first couple of answers to your first post.


  • Advertisement
Advertisement
Advertisement