Advertisement
Help Keep Boards Alive. Support us by going ad free today. See here: https://subscriptions.boards.ie/.
https://www.boards.ie/group/1878-subscribers-forum

Private Group for paid up members of Boards.ie. Join the club.
Hi all, please see this major site announcement: https://www.boards.ie/discussion/2058427594/boards-ie-2026

secure watch hkc SIRO install

  • 08-05-2018 10:38AM
    #1
    Fingers Mcginty
    Registered Users, Registered Users 2 Posts: 2,607 ✭✭✭


    Hi, I have the aforementioned alarm panel. Before it was handy when the alarm was triggered my wife and i would get a text on our mobiles.
    I recently got windows installed and one of the wondow sensors had 2 wires running to my phone line. I had to disconnect these wires from the window sensor and now i'm getting a line fault on my control panel understandably . I can still set the alarm though.
    I am getting siro installed and they will be disconnecting the phone line permanently so is there any way of getting rid of the amber line fault on the display?


Comments

  • #2
    fred funk }{
    Registered Users, Registered Users 2 Posts: 6,846 ✭✭✭fred funk }{


    You need engineer access to remove the line fault condition.


  • #3
    Fingers Mcginty
    Registered Users, Registered Users 2 Posts: 2,607 ✭✭✭Fingers Mcginty


    What about disconnecting anything on the PCB?


  • #4
    Fingers Mcginty
    Registered Users, Registered Users 2 Posts: 2,607 ✭✭✭Fingers Mcginty


    I tried the engineering code that's on the pcb 4567 and surprise surprise it doen't give me access


  • #5
    fred funk }{
    Registered Users, Registered Users 2 Posts: 6,846 ✭✭✭fred funk }{


    Fingers Mcginty wrote: »
    What about disconnecting anything on the PCB?

    The panel is reading the 50vdc from the phone line and if it drops it gives a line fault. You need to turn it off from the programming.


Advertisement
Advertisement