Advertisement
Help Keep Boards Alive. Support us by going ad free today. See here: https://subscriptions.boards.ie/.
If we do not hit our goal we will be forced to close the site.

Current status: https://keepboardsalive.com/

Annual subs are best for most impact. If you are still undecided on going Ad Free - you can also donate using the Paypal Donate option. All contribution helps. Thank you.
https://www.boards.ie/group/1878-subscribers-forum

Private Group for paid up members of Boards.ie. Join the club.

Quantum 70 re-assign devices to zones

  • 28-12-2017 03:25PM
    #1
    jaydev
    Registered Users, Registered Users 2 Posts: 42 ✭


    Hi all,

    Looking for a little advice on setting up a HKC Quantum 70.

    I seem to have detected and identified my first RF device into the wrong zone. It defaulted to zone 1 which was named as the front-door rather than zone 8 which was the back door.
    Is it possible to move a device to a different zone? Didn't see anything regarding this in the setup manual.

    Not sure if this was user error or not - but would be helpful to know if this is possible for future reference.
    Of course I could always just rename my existing zones :-)

    Thanks for any advice.
    Tagged:


Comments

  • #2
    altor
    Registered Users, Registered Users 2 Posts: 12,029 ✭✭✭✭altor


    jaydev wrote: »
    Hi all,

    Looking for a little advice on setting up a HKC Quantum 70.

    I seem to have detected and identified my first RF device into the wrong zone. It defaulted to zone 1 which was named as the front-door rather than zone 8 which was the back door.
    Is it possible to move a device to a different zone? Didn't see anything regarding this in the setup manual.

    Not sure if this was user error or not - but would be helpful to know if this is possible for future reference.
    Of course I could always just rename my existing zones :-)

    Thanks for any advice.

    You will need to go into rf device menu and remove the device.
    The scan for devices, press quit and use the # button to scroll to the zone you want the device installed on.
    When you have this, open and close the tamper to I'd onto the system.

    www.altor.ie



  • #3
    jaydev
    Registered Users, Registered Users 2 Posts: 42 ✭jaydev


    OK cool thanks. I don't think I had realised that I had to scroll to the desired zone BEFORE closing the device; asumed that it was a choice AFTER closing and as part of the ID process. But sounds like I have to chose the zone to ID into and then close tamper.
    Thanks for the clarification.
    All rest working a dream now!


  • #4
    altor
    Registered Users, Registered Users 2 Posts: 12,029 ✭✭✭✭altor


    jaydev wrote: »
    OK cool thanks. I don't think I had realised that I had to scroll to the desired zone BEFORE closing the device; asumed that it was a choice AFTER closing and as part of the ID process. But sounds like I have to chose the zone to ID into and then close tamper.
    Thanks for the clarification.
    All rest working a dream now!

    No problem, glad you are on the right road now.

    www.altor.ie



Advertisement