Circular saw guard spring problem

JaCrispy · 2017-10-31 10:56:37

Hi, My Einhell BT-CS circular saw spring popped of the guard and I cannot find where it went. Looking at the part diagram below I can see its part #25 but I cannot see how it attaches/operates the guard. Any ideas anybody?

31-10-2017 11:56AM

#1

JaCrispy

Registered Users, Registered Users 2 Posts: 638 ✭✭✭

Join Date: July 2015

Posts: 590

Hi,

My Einhell BT-CS circular saw spring popped of the guard and I cannot find where it went. Looking at the part diagram below I can see its part #25 but I cannot see how it attaches/operates the guard.

Any ideas anybody?

0

Comments

#2 31-10-2017 02:52PM

bonzodog2

Registered Users, Registered Users 2 Posts: 6,353 ✭✭✭

Join Date: October 2007

Posts: 6087

I'd say the spring's other end should connect to piece 33, 23 or 5

0
#3 31-10-2017 06:58PM

the_pen_turner

Registered Users, Registered Users 2 Posts: 7,795 ✭✭✭

Join Date: November 2015

Posts: 7629

usually there is a slot in the side of the main casing. the spring attaches to that and stretches in the slot. the slot keeps it aligned. it should attach to the guard up near the little handle part.
it is a fiddly job to fix

0