Advertisement
Help Keep Boards Alive. Support us by going ad free today. See here: https://subscriptions.boards.ie/.
https://www.boards.ie/group/1878-subscribers-forum

Private Group for paid up members of Boards.ie. Join the club.
Hi all, please see this major site announcement: https://www.boards.ie/discussion/2058427594/boards-ie-2026

Handle/knob for press door - where would I buy

  • 21-10-2017 06:17PM
    #1
    Registered Users, Registered Users 2 Posts: 623 ✭✭✭


    Hi I tried woodies for these but cannot get similar to attached picture. Any idea where I might get them around dublin ? would b&q, panel centre have similar ? Thanks


Comments

  • Registered Users, Registered Users 2 Posts: 623 ✭✭✭harry999


    Any ideas on this ? Thks


  • Registered Users, Registered Users 2, Paid Member Posts: 19,330 ✭✭✭✭elperello


    If you know who supplied the units that's your best place to start.
    After that it's a case of checking in B&Q, Homebase etc.
    You could also try EBay.
    It could be a long slog to find the exact match.
    Maybe you could move one from somewhere less prominent where a different design won't look too out of place.


  • Registered Users, Registered Users 2 Posts: 1,434 ✭✭✭Rancid


    Good suggestions there.

    Homestyle DIY in Mary Street, Dublin 1 is another place you could try. Bring one in with you, if they don't have the exact one, they might have similar enough and swap around as suggested above.


  • Registered Users, Registered Users 2, Paid Member Posts: 19,330 ✭✭✭✭elperello


    Rancid wrote: »
    Good suggestions there.

    Homestyle DIY in Mary Street, Dublin 1 is another place you could try. Bring one in with you, if they don't have the exact one, they might have similar enough and swap around as suggested above.

    That's a blast from the past!!
    A great shop, I honestly didn't know they were still there.
    Should get out more:)


  • Registered Users, Registered Users 2 Posts: 2,430 ✭✭✭J.R.


    http://woodworkers.ie/

    you could try here as well


  • Advertisement
  • Registered Users, Registered Users 2 Posts: 22,443 ✭✭✭✭endacl


    Might be a better idea and a lot less hassle to find a design you like and just replace them all?


  • Registered Users, Registered Users 2 Posts: 10,493 ✭✭✭✭dodzy


    endacl wrote: »
    Might be a better idea and a lot less hassle to find a design you like and just replace them all?
    Best suggestion above.
    Panelling centre (trade counter) - decent range, all on display board.


  • Closed Accounts Posts: 27,833 ✭✭✭✭ThisRegard


    Noyeks Newman had the best selection last time I was looking for new knobs for a kitchen.


Advertisement
Advertisement