Needed... Blind bearing puller! N Kildare, Dublin area

velo.2010 · 19-06-2017 01:38PM #1

Has anyone got a Norse blind bearing puller set that I could borrow for a quick job? e120 in E Fox which is too much to pay for simply taking out a stuck bearing race. No problem throwing a few quid your way for the loan. It looks like this.

North Kildare, Dublin area. Thanks.

antiskeptic · 19-06-2017 08:51PM

velo.2010 wrote: »

Has anyone got a Norse blind bearing puller set that I could borrow for a quick job? e120 in E Fox which is too much to pay for simply taking out a stuck bearing race. No problem throwing a few quid your way for the loan. It looks like this.

North Kildare, Dublin area. Thanks.

Fitter in my work used to use an ordinary stick arc welder to get these out. He'd weld a bead on the inside run of the race and the race would crack. Depend on the material the bearing is set into (e.g. not plastic!) - although I recall him doing it on aluminium motor housings with success.

jack of all · 20-06-2017 07:44AM

Depending on the type of blind bearing you might be able to remove it using hydraulic pressure- plenty of videos on youtube with lads removing blind bearings using grease and rags, packed in until the bearing starts to move.

velo.2010 · 20-06-2017 11:40AM

Thanks for the tips but I need a blind bearing puller, ideally the one above with the wider attachments to fit the race. Any ideas of where I could borrow one would be welcome. Cheers.

velo.2010 · 23-06-2017 05:09PM

Hello again. Final call on this. I need to borrow a blind bearing puller with wide collets like the one pictured above. I'll pay for the use. Thanks.

Needed... Blind bearing puller! N Kildare, Dublin area

Comments