How to drill hole in stainless steel kitchen sink

mrcheez · 15-12-2016 11:19AM #1

I posted a question earlier about getting a "step drill bit" to drill holes into a stainless steel kitchen sink, based on a recommendation in this video: https://www.youtube.com/watch?v=ORXqvOevRbA

but just in case you cannot buy those drill bits in Ireland, is there any other way of drilling the hole? It's for a mixer tap and bizarrely didn't come with pre-cut holes.

The circular drill bits just wear down as they do in the video.

Alun · 15-12-2016 11:33AM

Something like this?

https://www.amazon.co.uk/Wolfcraft-3762000-8-inch-Cutter-Bearing/dp/B002OHM6LS/ref=pd_cp_60_2?_encoding=UTF8&psc=1&refRID=9880B19ZFX1JC99K5E3K

You still have to drill a pilot hole, but a relatively small one to get the bolt of the cutter through.

You can get the cutter in Ikea too if that's convenient ...

http://www.ikea.com/ie/en/products/kitchen-products/kitchen-taps-sinks/fixa-2-piece-tool-set-art-28512100/

mrcheez · 15-12-2016 11:42AM

Alun wrote: »

Something like this?

https://www.amazon.co.uk/Wolfcraft-3762000-8-inch-Cutter-Bearing/dp/B002OHM6LS/ref=pd_cp_60_2?_encoding=UTF8&psc=1&refRID=9880B19ZFX1JC99K5E3K

You still have to drill a pilot hole, but a relatively small one to get the bolt of the cutter through.

You can get the cutter in Ikea too if that's convenient ...

http://www.ikea.com/ie/en/products/kitchen-products/kitchen-taps-sinks/fixa-2-piece-tool-set-art-28512100/

cool, worth a shot thanks!

Alun · 15-12-2016 11:44AM

I imagine you'd probably get something similar in any building/plumbing suppliers too.

The Mulk · 15-12-2016 11:50AM

mrcheez wrote: »

cool, worth a shot thanks!

You'll get a cone bit in the video in any electrical wholesale, they're not cheap.
I've used a holesaw in reverse with cutting compound to drill stainless steel before, wasn't quick!

mrcheez · 15-12-2016 12:52PM

The builders have gone off to pick up the IKEA device, interesting to see if it works, thanks

Steve · 15-12-2016 08:07PM

I stopped watching the video when I saw the speed he was cutting at, way to fast.

Only way to cut stainless is lots of pressure, slow speed, and use oil or cutting fluid. Anything else will harden the stainless and blunt / melt the bit. Most important is keep the heat under control.

How to drill hole in stainless steel kitchen sink

Comments