Advertisement
Help Keep Boards Alive. Support us by going ad free today. See here: https://subscriptions.boards.ie/.
https://www.boards.ie/group/1878-subscribers-forum

Private Group for paid up members of Boards.ie. Join the club.
Hi all, please see this major site announcement: https://www.boards.ie/discussion/2058427594/boards-ie-2026

Manrose inline extractor fans

  • 13-12-2025 10:06AM
    #1
    Registered Users, Registered Users 2 Posts: 31


    So I have a ceiling fan in my upstairs bathroom that's given up the ghost. It was vented into the attic but not out through the roof or eaves, just a hole in the insulation where it disperses (bad I know 😕). I've been looking at a replacement and I came across a Manrose brand that's an inline fan type, mounted on a joist. Couple of questions:

    - are these inline fans better than the ceiling mounted ones? Are Manrose a good brand?

    - would most electricians be happy to crawl into the corner of an attic to fit them?

    - is it ok to vent it out through a vent tile in the roof?

    - is there anything else to be aware of, like I read about moisture going back down through the ducting if It's pointing upwards?

    Tia

    Post edited by BrokenJetpack on


Answers

  • Registered Users, Registered Users 2 Posts: 13,045 ✭✭✭✭Calahonda52


    How well ventilated is the attic.

    Roof tile vents are hard to retrofit correctly and the cure might be worse than the disease.

    If they are not correctly flashed they let rain in

    If its close to the side of the house you might be able to put the vent in the soffit, with a well supported semi circular loop

    In line may not have a backdraught flap and if mounted on the joist may vibrate

    “I can’t pay my staff or mortgage with instagram likes”.



  • Registered Users, Registered Users 2 Posts: 31 BrokenJetpack


    Thanks, I think it's reasonably well ventilated in that it's pretty cold up there and always seems a bit draughty. That's a good call re venting through the soffit, hadn't thought of that👍️



  • Registered Users, Registered Users 2 Posts: 10 greenbin2


    I had a similar setup and I piped it down (dormer) and out thorough soffit and facia

    It was useless, took hours to reduce humidity, so a few years later I sealed up the vent, and drilled a new one out the side wall of the bathroom



  • Registered Users, Registered Users 2 Posts: 511 ✭✭✭hargo


    I put one in over 20 years ago, piped it out through the soffit and it works great. Previously had ceiling fan straight into the attic and it was useless. It has been left on by mistake for hours several times and no issue with it burning out. One warning I was given at the time if you are using a flexible pipe make sure it is well supported so that you don't get a build up of water in one place as it may burst eventually, using a 100mm pipe over a long distance is best.



  • Registered Users, Registered Users 2 Posts: 13,045 ✭✭✭✭Calahonda52


    Wrong re long distance, pressure loss on a long pipe will reduce the effectiveness

    long L / small D = big impact eg

    1m/.1 = 10

    vs

    .5/.15 = 3.3

    [Long L + big D = sin urlár eile ar fad!}

    image.png

    OP, fit a 6" fan on a timer

    “I can’t pay my staff or mortgage with instagram likes”.



  • Advertisement
Advertisement
Advertisement