Update analogue immersion timer to digital

mailforkev

I’ve got an analogue timer attached to my immersion as per the picture. The timer is a bit noisy as it ticks and clicks on/off so I’d like to replace it with something digital and ideally slightly smart. Any suggestions would be very welcome.

10-10-20

https://www.boards.ie/discussion/2058404935/update-analogue-immersion-timer-to-digital

The EPH or Horstman 1-channel digital timer is your only man.

https://www.electricalwholesaler.ie/Products/Solar-Heating-Safety/HeatersHeatingControlsHandDryers/TimeclocksHeatControls/R17/

Any electrical wholesale will have them.

You might need to move the wiring slightly though.

Wearb

https://www.boards.ie/discussion/comment/123323171#Comment_123323171

Are you mistake in your reply? That would not be capable of switching the required load.

mailforkev

I was kind of hoping for one that would fit into the same footprint for convenience.

https://www.amazon.ie/Immersion-Heater-Switch-Control-Assistant/dp/B0CKTFNCB3/ref%3Dmp_s_a_1_1?crid=ZB293L5ZE3PQ&dib=eyJ2IjoiMSJ9.exBsC3y7rtDeE5yQsBsSUEg8bibWfCaIJVu1CnPcHvepz-3KTk1mzZ3QkVYvdkxFQQfjYErv22d_q3-JQ1_NdyUJqiXIq3gtPDeXSjeEs54bdesjZ_k-HM4P_kOHwqbt3VXukniNSKMw71mP6xl0y7DQweiAEH8WLr__nv6_wkAiQRsp1VQxVhO3KlRhWhS2aiGekxQNam6DvVAKAQ4QRQ.Fo6t9kCFihf6FFcXJWjSOGQFbRYHbYolOeA_wiAxCVY&dib_tag=se&keywords=wifi+timer+switch&qid=1743683341&sprefix=wifi+timer%2Caps%2C67&sr=8-1

Something like this any use?

10-10-20

https://www.boards.ie/discussion/comment/123323284#Comment_123323284

Whoops, correct. It's the immersion controller rather than the central heating controller.

Here's the EPH version at 13A:

https://www.ephcontrols.com/section/imc/

blackbox

I actually think you should have a 20A switch for an immersion heater. They are typically 3kW.