HKC 1070 - PIR point ID

frthdo

I have installed this system 8 years ago with expertise from this forum. All worked so well that I now have to refresh what I learned then.

Alarm showing fault and internal echo activating. A PIR point ID is causing a problem and blue light was on continuously. I have replaced the PIR and there is no change. I have removed the device from the system and indicates no ID now. I have not been able to add and ID the device. I have disconnected the PIR (+-and data) and displays as such under "Locate devices". I cannot set the alarm as it shows a comms fault from this PIR even though I have disconnected the 3 wires. A second PIR on point ID is operating and displaying as normal in the Devices Menu.

Any suggestion appreciated.

frthdo

Also, when PIR was faulty but had ID I could part set the perimeter zones.

altor

https://www.boards.ie/discussion/2058299392/hkc-1070-pir-point-id

In devices menu, wired devices, you need to delete the faulty device.

The re id the new PIR.

Then you need to set up the PIR to be off in Part guard A/B

frthdo

Thank you Altor. I was able to delete the device OK but not re id the device. Following advice I deleted both ID devices on this zone and then was able to re id both at the same time. Problem sorted and thanks again for posting.

altor

https://www.boards.ie/discussion/comment/120697080#Comment_120697080

Brilliant, thanks for the update