Advertisement
Help Keep Boards Alive. Support us by going ad free today. See here: https://subscriptions.boards.ie/.
If we do not hit our goal we will be forced to close the site.

Current status: https://keepboardsalive.com/

Annual subs are best for most impact. If you are still undecided on going Ad Free - you can also donate using the Paypal Donate option. All contribution helps. Thank you.
https://www.boards.ie/group/1878-subscribers-forum

Private Group for paid up members of Boards.ie. Join the club.
Hi all, please see this major site announcement: https://www.boards.ie/discussion/2058427594/boards-ie-2026

Hkc tamper after replacing batteries

  • 24-06-2021 12:38AM
    #1
    purple hands
    Registered Users, Registered Users 2 Posts: 1,071 ✭✭✭


    Got the rf low batt faults on three pir sensors, so replaced the batteries today, after using engineer code

    Now getting a tamper fault for one of the zones a few hours later, so I must have gone wrong somewhere

    How can I clear the tamper fault? Is there more to resolving the original fault than just replacing the batteries? Thanks


Comments

  • #2
    altor
    Registered Users, Registered Users 2 Posts: 12,038 ✭✭✭✭altor


    purple hands wrote: »
    Got the rf low batt faults on three pir sensors, so replaced the batteries today, after using engineer code

    Now getting a tamper fault for one of the zones a few hours later, so I must have gone wrong somewhere

    How can I clear the tamper fault? Is there more to resolving the original fault than just replacing the batteries? Thanks

    There is 2 tampers on the PIRs, front and back.
    Check the springs in the sensor to make sure its closed correctly

    www.altor.ie



Advertisement