How to hang this mirror?

Cyrus

I presume the obvious answer is measure twice and make sure you dont balls it up, but i just know ill end up with one screw marginally out

is there any knack that can be used to make sure i am accurate?

80cm wide mirror with two mounting points part way down the mirror.



Its going into a wall panel that is 140 cm long and 86 cm across.

GhostyMcGhost

One tip I saw is to use making tape on the back along where the screw holes are

https://www.instructables.com/Perfect-Screw-Alignment-for-Screw-Mounted-Equipmen/

Lurching

Was just about to mention the masking tape trick.
Either way, measuring is key!
At least it's oval though, so if it's not 100% level, you wont really notice.

Cyrus

GhostyMcGhost wrote: »

One tip I saw is to use making tape on the back along where the screw holes are

https://www.instructables.com/Perfect-Screw-Alignment-for-Screw-Mounted-Equipmen/

perfect, i knew there would be something relatively simple, thanks for that. :cool: