Advertisement
Help Keep Boards Alive. Support us by going ad free today. See here: https://subscriptions.boards.ie/.
If we do not hit our goal we will be forced to close the site.

Current status: https://keepboardsalive.com/

Annual subs are best for most impact. If you are still undecided on going Ad Free - you can also donate using the Paypal Donate option. All contribution helps. Thank you.
https://www.boards.ie/group/1878-subscribers-forum

Private Group for paid up members of Boards.ie. Join the club.

Astec Alarm (Tamper fault)

  • 06-07-2018 05:53PM
    #1
    Dubliner28
    Registered Users, Registered Users 2 Posts: 1,785 ✭✭✭


    Hi gang
    We have recently installed a new front door and the sensor will no longer fit the new one.

    When I try to set the alarm to bypass the door
    "Zone 1 Tamper" comes up.
    Basically I cannot bypass this "zone" or set the house alarm now. (The wire has been cut at the door)

    How can I bypass this zone?


Comments

  • #2
    KoolKid
    Moderators, Home & Garden Moderators, Technology & Internet Moderators Posts: 24,790 Mod ✭✭✭✭KoolKid


    I'd be more cencerned at sorting out the problem. The front door is an important part of the system.. You could eliminate from the system by using the 1.5k resistor across the zone to close it off. But this cable problem needs to be sorted in the long term.


  • #3
    davidconroy46
    Registered Users, Registered Users 2 Posts: 269 ✭✭davidconroy46


    As Koolkid said, your front door is imporant, if i were you i would try and find the cable, shouldnt be to hard to find. But to close of the zone for now you will need 1.5k resistor.


Advertisement