Hkc securewave to honeywell ag6 bell box

murt07

Hi guys im in the process of changing my alarm and was wondering what way to connect between ag6 bell box and securewave panel.i have terminals st- r-- sw- v+ and v- in the bell box.also do i leave the resistor between tamper return and saab hold in place on the panel side if i use this type of bellbox.

KoolKid

Id say

St Strobe -
Sw External -
V+ External +
V- BHO
R Tamper Return in series with the required resistor.

murt07

Thanks kool kid il give that a try tomorrow and see how it goes

murt07

Thanks kool kid that worked a treat .at the moment i have the resistor in series in the panel is it better to move it to the bellbox or okay as it is

KoolKid

Best practice would be to have it end of line at the bell.

murt07

Ok cheers for that kool kid

Roger11

Hi,

I have a similar issue, I am connecting a Vanderbilt 4320 panel to a HKC SABB external bell box. The HKC bell box comes with a 4.7K tamper resistor fitted and the Vanderbilt panel comes with a 2.2K resistor to be fitted in series with the tamper wire. My question is should I replace the 4.7K resistor with the 2.2K resistor or should both resistors be fitted ?

KoolKid

You need to use the 2.2 k resistor.

Roger11

Thanks KoolKid. So just use the 2.2K resistor ?

KoolKid

Yes. The panel determines the resistance required , not the bell.