Lathe NVR Switch

mayo.mick · 2016-11-16 19:23:07

Was doing some turning this evening and the no volt release switch started playing up on my lathe. Switch it off but would switch back on itself again. Sometimes would be OK but could then switch on itself at any time. Had to resort to switching off at the socket for safety, had an odd shaped piece in the chuck that would…

16-11-2016 07:23PM

#1
mayo.mick

Registered Users, Registered Users 2 Posts: 2,532 ✭✭✭

Join Date: June 2010

Posts: 2435
Was doing some turning this evening and the no volt release switch started playing up on my lathe. Switch it off but would switch back on itself again. Sometimes would be OK but could then switch on itself at any time. Had to resort to switching off at the socket for safety, had an odd shaped piece in the chuck that would take the knuckles off you even with 100% concentration! :eek:

Has anyone here replaced an NVR on any of their machines? Are they standard, size and wiring? It will be tomorrow before I get back to it to take apart but I've done a quick search and this looks like the one, or near enough.

Swinford Weather

Tagged:

no volt release switch

nvr switch

lathe switch

0

Comments

#2 18-11-2016 10:40AM

recipio

Registered Users, Registered Users 2 Posts: 2,806 ✭✭✭

Join Date: January 2005

Posts: 2711

Check the plug for a loose connection and change the plug fuse. NVR switches rarely go wrong but if you have to change it out make sure it will fit in the original mount.

0