Advertisement
Help Keep Boards Alive. Support us by going ad free today. See here: https://subscriptions.boards.ie/.
https://www.boards.ie/group/1878-subscribers-forum

Private Group for paid up members of Boards.ie. Join the club.
Hi all, please see this major site announcement: https://www.boards.ie/discussion/2058427594/boards-ie-2026

orchid v6 clone

  • 18-04-2015 08:13PM
    #1
    noelyf
    Registered Users, Registered Users 2 Posts: 39 ✭


    Took the plunge and ordered one of these from fasttech. It'll be my first RTA so any advice on coils, wicking etc. would be most appreciated : )


Comments

  • #2
    jousting with chairs
    Registered Users, Registered Users 2 Posts: 935 ✭✭✭jousting with chairs


    I've just re-wicked mine so I took a snap of it.

    12 wraps of 26g for .6 ohms.
    This build is better on a regulated device at between 25 -35w, the ramp up time is a bit much on a mech.

    Make sure your Cotton is snug in the coil but not too tight, cut it about a mm past the posts, wet it and just lay it on the deck without sticking any in the juice channels.
    [IMG][/img]FBtGoxd.jpg


  • #3
    nuttyboy79
    Registered Users, Registered Users 2 Posts: 517 ✭✭✭nuttyboy79


    Tidy coils mate mine look like a slinky


  • #4
    noelyf
    Registered Users, Registered Users 2 Posts: 39 ✭noelyf


    Cheers :) that's the sort of info I'm looking for....is that ohm reader from fasttech, I've seen em online from an irish retailer for €15 too.
    Thanks for the feedback mate :)


  • #5
    jousting with chairs
    Registered Users, Registered Users 2 Posts: 935 ✭✭✭jousting with chairs


    No bother.
    Yeah, FT ohms meter,
    I have it a few months now but it's starting to get a bit temperamental.
    I have one of the Smok ones from an Irish site, much better quality,it only reads to 1 decimal so no good for very low sub-ohm vaping but it's grand if you don't plan going below .2 or so.


Advertisement