Advertisement
If you have a new account but are having problems posting or verifying your account, please email us on hello@boards.ie for help. Thanks :)
Hello all! Please ensure that you are posting a new thread or question in the appropriate forum. The Feedback forum is overwhelmed with questions that are having to be moved elsewhere. If you need help to verify your account contact hello@boards.ie
Hi there,
There is an issue with role permissions that is being worked on at the moment.
If you are having trouble with access or permissions on regional forums please post here to get access: https://www.boards.ie/discussion/2058365403/you-do-not-have-permission-for-that#latest

orchid v6 clone

  • 18-04-2015 8:13pm
    #1
    noelyf
    Registered Users, Registered Users 2 Posts: 39 ✭


    Took the plunge and ordered one of these from fasttech. It'll be my first RTA so any advice on coils, wicking etc. would be most appreciated : )


Comments

  • #2
    jousting with chairs
    Registered Users, Registered Users 2 Posts: 933 ✭✭✭jousting with chairs


    I've just re-wicked mine so I took a snap of it.

    12 wraps of 26g for .6 ohms.
    This build is better on a regulated device at between 25 -35w, the ramp up time is a bit much on a mech.

    Make sure your Cotton is snug in the coil but not too tight, cut it about a mm past the posts, wet it and just lay it on the deck without sticking any in the juice channels.
    [IMG][/img]FBtGoxd.jpg


  • #3
    nuttyboy79
    Registered Users, Registered Users 2 Posts: 481 ✭✭nuttyboy79


    Tidy coils mate mine look like a slinky


  • #4
    noelyf
    Registered Users, Registered Users 2 Posts: 39 ✭noelyf


    Cheers :) that's the sort of info I'm looking for....is that ohm reader from fasttech, I've seen em online from an irish retailer for €15 too.
    Thanks for the feedback mate :)


  • #5
    jousting with chairs
    Registered Users, Registered Users 2 Posts: 933 ✭✭✭jousting with chairs


    No bother.
    Yeah, FT ohms meter,
    I have it a few months now but it's starting to get a bit temperamental.
    I have one of the Smok ones from an Irish site, much better quality,it only reads to 1 decimal so no good for very low sub-ohm vaping but it's grand if you don't plan going below .2 or so.


Advertisement