Advertisement
Help Keep Boards Alive. Support us by going ad free today. See here: https://subscriptions.boards.ie/.
https://www.boards.ie/group/1878-subscribers-forum

Private Group for paid up members of Boards.ie. Join the club.
Hi all, please see this major site announcement: https://www.boards.ie/discussion/2058427594/boards-ie-2026

pad9.3

  • 30-06-2012 12:45PM
    #1
    Joeface
    Registered Users, Registered Users 2 Posts: 2,920 ✭✭✭


    Hopefully this is the right section ...

    Currently been moved to this software ...(horrible i might add)

    has anyone any experience importing for Altuim designer to Pads DXDesigner

    Thanks
    Joe


Comments

  • #2
    si_guru
    Registered Users, Registered Users 2 Posts: 2,345 ✭✭✭si_guru


    Did you try reading the Evaluation Guide installed with the Software? that has a step-by-step SCH to PCB guide.

    Importing Altium is easy enough using the PADS translators. Did you hit a specific problem?


  • #3
    Joeface
    Registered Users, Registered Users 2 Posts: 2,920 ✭✭✭Joeface


    thanks for the reply . but managed to get the design complete.

    That said . will never be using Pads or DX designer again. Very poor integration between layout and schematic. personal opinion but it while some of the stuff in pads router is on the brilliant side of things the rest is very cumbersome and not user friendly at all


  • #4
    si_guru
    Registered Users, Registered Users 2 Posts: 2,345 ✭✭✭si_guru


    Between you and I - PADS Logic is better than DxD for integration.

    Drop me a line if you ever need (free) PADS help!


Advertisement